Honda Tsivik
+ Cars of the mark of It Treats Full text and Honda Civic With care
+ Maintenance education
+ Regular maintenance
+ Motor
+ To cool system and heating
- System of provision of power and launch
Specifications
To leave pressure in a power supplies to the system
Check of usefulness of functioning of the bomb / pressure of fuel of fuel
Check of a state and substitution of lines of fuel and his connections of nipple
Removal and installation of the bomb of fuel
Check of a state and substitution of the sensor of consumption of fuel
Removal and installation of the tank of fuel
To clean and repair of the tank of fuel - general information
Removal and installation of meeting of the purifier of air
Removal, installation and agreement of a thread of a gas pedal
System of electronic injection of fuel (EFI) - the general information
Check of usefulness of functioning of system of injection
Removal and installation of the case of a regulator
Removal and installation of the regulator of pressure of fuel
Removal and installation of the road of fuel and injectors of fuel of injectors of fuel
Launch system - the general information
+ Electric motor equipment
+ Systems of control of the motor
+ Box of dislocation of gear
+ Union and ends of power
+ Brakes system
+ Support of the triangular form of interruption and direction
+ Body
+ Electric side equipment
|
Check of a state and substitution of lines of fuel and his connections of nipple
Steel tubes
|
|
1. Only use tubes from steel of high force of the famous producers as replaceable sections.
2. Remember that the tubes of copper and of aluminum are not able to hold the loadings of vibration that appear in the use the car.
3. One does not forget of that the fuel lines in the equipped models of the system of the injection will maintain the high internal pressure.
4. Very often in shops of company of motor accessories it is possible to acquire the sections of equipped metal tubes of the woodcarving of mouths of nipple. During the relief and the delay in the nipple the connections use two pulls to avoid a provorachivaniye of a reciprocal part of the capture. Without fail check a condition of the connections of nipple of sealing rings used for the hunting. At the same time substitute the worn-out or mechanically damaged rings. Try to use only details of company as component replaceable. |
|
Flexible hoses
|
|
When it substitutes hoses of fuel only it uses component company when they were calculated according to the high internal pressure. |
|
|
|
|
1. The flexible fuel hoses have to put themselves not more near to what in 10 cm of component ones of the system of the production of the carried out gases and they are not more shut than in 25 cm of the catalytic converter. It looks at that fuel on which the lines did not border to body elements and component of a support of the triangular form of interruption (companion saw an illustration). The least admissible size of a slit does 6,3 mm. |
|
|
Removal and installation
|
|
1. The heap pressure in a system of provision of power (to see the pressure that Falls in a system of provision of power).
2. Launch the section of a way of fuel that is I subject to be demolished from her intermediary armbands of the fixation to the bottom of the car.
3. Collars of launch of fixation of hoses of rubber to tubes from steel of a way of fuel. Since it makes a lack of interest of a hose revolve in a tube.
|
|
4th. The installation is done upside-down. Do not forget of substituting rings of fighter of screwed connections of nipple. |
|
|
4b. The lavadores seal of a hollow pin of the knot of nipple in the fuel filter also they are subject to the substitution without fail (companions see illustrations). |
|
|
Repair The damaged sections of lines of fuel (tubes or hoses) have to be withdrawn and news, production of company to be substituted. |
|
