Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Removal and installation of meetings of advanced and rear bumpers

Bumpers front line player

ORDER OF REALIZATION

1. Lift the brake of parking, the car and establish it to a poddomkratta in stakes.
2. Desconecte a negative wire of the battery.

If the stereosystem established in the car if it equips of a security code before desconectar the battery they secure what has the correct combination of the entry of the system sound in the action!

3rd. Result the central screws of the fixation of the fabric of antispray.

3b. Below the car there result screws of the fixation of inferior edges of a bedcover of bumpers (companions see illustrations).

4. I work for arches of advanced wheels, result screws of a bedcover of bumpers to the drawer with lock (companion sees an illustration).

5. Result pins of the fixation of a bedcover of bumpers to the chassis of the car (companion sees an illustration).

6. Give screws (or, in some models, take plastic armbands) the fastenings of the superior edge of a mistake (companion sees an illustration) and withdraw the last of the car.

The plastic armbands are taken for a poddevaniye for the convenient instrument after the preliminary launch of the central pin.

7. Taken of Disunite of the removal of prevention of electrical system of bumpers. In case of the necessity they withdraw the established knitsa since both ends of bumpers then result four pins and withdraw bumpers of the car.
8. The installation is done upside-down.

Bumpers bottom

ORDER OF REALIZATION

1. Lift the brake of parking, the car and establish it to a poddomkratta in stakes.

2. Below the car there take plastic armbands and result screws of the fixation of the inferior edge of a bedcover of bumpers bottom (companion sees an illustration).

3. Result screws of the fixation of a mistake to arches of rear wheels (companion sees an illustration).

4th. A haulage company / door of rear baggage opens a covering.

4b. Of inside the baggage the compartment gives screws and nuts of the fixation of the superior edges of a bedcover of bumpers (companions see illustrations). Withdraw a bedcover of bumpers of the car.

5. For the removal of the part of load of a few rivets of furadeira of bumpers of the fixation of the isolation of foam, soon give pins and withdraw the meeting of bumpers of the car.
6. The installation is done upside-down.