Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Removal, installation and agreement of provision of doors

The doors of the car have the weight nachitelny, therefore, it will be reasonable to hold with the help of the spectator.

Removal and installation

ORDER OF REALIZATION

1. Completely lower the glass, soon desconecte a negative wire of the battery.
2. Open a door against the stop and support it one monkey or wooden grindstones.
3. Withdraw the list of a few internal articles of tapestry and the water filter (to see the Removal and the installation of a few internal articles of tapestry of doors).
4. Mark and disunite all the electric captures, soon launch an electrical system of armbands in the door meeting.
5. Of a separate door it put between him and a body the tube of direction of rubber. Take the braid of an electrical system it passed by the direction tube and withdraw it of a door.

6. Beat the central pin of an emphasis of door (companion sees an illustration).

7. Round crazy lead levels a marker, when they marked situation in a door.

8. Ask a spectator to take a door and to give pins of the fixation of crazy levels (companion sees an illustration). Together withdraw a door of the car.

9. The installation is done upside-down.

Agreement

ORDER OF REALIZATION

1. The fairness of an agreement of a door in a body opening has the critical value of the point of view of the usefulness of the functioning of the meeting of door. First of all to appreciate the size of a play of side of axial fingers of knots of door. Completely open a door and tug links down. If the play of side of a door exceeds 1,6 mm, the knots must be substituted.

2. Since the realization of the correction of a door in an opening weakens pins of the fixation of knots in a hoof of the car (companion sees an illustration). The door one can consider that established really when his superior edge falls in a shut position it is parallel to a reduction of roof of the car; the first line (behind in a back door) you carry at the same time it will appear aflush with the surface of a wing, and more low – with the airplane preliminary verdict. If there is not possible the simple shift of a door will carry out an objective, it is necessary to get a beating lavadores of agreement of the necessary thickness. The lavadores are enclosed below crazy levels (both in a body, and in a door) and can be acquired in shops of motor accessories.

3. The correct operation of the mechanism of closure can carry out updating of the provision of the drummer of the lock in the vertical direction (to see an illustration I lower). Since the evaluation of the size of the shift drives around a plate of the base of the drummer a marker. Weaken the fixation and do the necessary agreement – the latch will enter in the gear with the central part of the drummer.

4. In the conclusion they adjust the position of the drummer in the horizontal direction, – the shut door will appear aflush with the surface of the torture / list of a rear wing and to be locked regularly at the same time (companion to see an illustration).