Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Removal, installation and agreement of provision of a monk's hood

Removal and installation

The list of a monk's hood has the decent weight, therefore, it is necessary to acquire the support of the spectator.

ORDER OF REALIZATION

1. The covering wings with special bedcovers or blankets only old of the protection they from the damage to the process of are demolished of a monk's hood.

2. A marker or a leadership of chertilka round leaders of crazy pins of a guarantee of the fairness of the fixation of a monk's hood in the meeting (companion sees an illustration).

3. Desconecte all the threads and wires that prevent the removal of a monk's hood.
4. Ask a spectator to take a monk's hood and him to result fixation pins crazy levels. Withdraw lavadores of agreement (if you arrange if they supply) and at the same time put them behind the pins that they must put themselves in an order organized for ends of a guarantee of the installation in the meeting strictly at the ancient places.
5. Withdraw a monk's hood.
6. The installation is done upside-down. During the installation to the place of a monk's old hood with the correct agreement of fixing pins and adjusting any problem of a lavador with his alignment in an opening of a compartment of reason it must not appear. If the substitution of a monk's hood is done, it is necessary to do the agreement of his situation.

Agreement

ORDER OF REALIZATION

1. The agreement of the provision of a monk's hood in an opening of a compartment of reason is done in the turn in the relevant party of crazy levels after being weakened of his fixation.
2. Since the determination of the size of the shift drives round levels of knots a marker.
3. Weaken the fixation and move knots in the necessary direction (execute the agreement without haste, in stages, moving levels of knots gradually of each approximation). Again hold tight pins, lower a monk's hood and she checks the fairness of an agreement in an opening.

4. The updating of the provision (in the vertical and horizontal airplanes) the meetings of a latch of the lock of a monk's hood in a basic plate of an electric heater can be in case of the fulfilled necessity – the monk's hood has to be closed densely and is quiet aflush with the wings surfaces. For the agreement of the leadership of lock round leaders of the pins of the fixation of the meeting of a latch a marker or a chertilka, soon weakens pins and move a latch in the necessary direction (companion sees an illustration). After the realization of the agreement strongly they hold tight pins of fixation.

5. In the conclusion they adjust the provision of pillows of rubber of a monk's hood in the list of support of electric heater (companion sees an illustration), trying to obtain this the monk's hood fell in a shut position aflush with wings.

6. The meeting of a latch of the lock of a monk's hood has the periodicamente (together with knots – they see Service of knots and locks of the car) being polished with the lubricant in a lithium base to avoid to stick and I use of bystry.