Removal and installation of the antenna of the radio-receiver
Civic models
Models of Full text
The mast of the antenna is equipped of the electric walk
|
|
1. Stick with an insulating tape to part of a wing of the car that goes round a mast of antenna of protection of a painting and covering of varnish. Give a nut of fixation and withdraw a remote lavador (companion sees an illustration). |
|
2. Ask a spectator to light the radio-receiver and to lift the antenna in the superior situation. Directing a mast of antenna in the process of the promotion, withdraw it of the car (companion sees an illustration). |
|
3. During the installation they unfold the antenna teeths behind and enter in teeths in the gear with a driving thread. Light the radio-receiver and allow to an electric motor to implicate a mast of antenna in a wing (companion to see an illustration). |
4. Establish at the place a remote lavador and screw a nut of fixation.
|
If the remote lavador is equipped of a flat selante, the last thing will enter in the capture, which is installed below a lavador. The fighter ring puts itself in a remote lavador. |
|
|
Electric motor of the walk of a mast of antenna
|
1. In models with a body since Sedan withdraws the list of a side internal tapestry articles in the baggage compartment. In the Car with bodywork the models withdraw the list of Bottom of a few internal articles of tapestry of the hall.
|
2. Give a nut of the fixation of the antenna, withdraw a lavador (to see an illustration). Give a nut of the fixation of an electric motor of driving (companion sees an illustration). Disunite to electric capture and a thread of antenna. Withdraw the meeting of an electric motor. |
3. The installation is done upside-down. |
|
|