Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Check of usefulness of functioning and substitution of switches of the panel

Considered in the present manual of the car they are equipped of cushions of security (men). When there are executing any work near to sensors of punches, a column of direction or the panel desconectam men (to see cushions of Security - the general information). It does not carry out the control of the men's models through any type of the diagnostic equipment.

Switch of activation of a tempostat

To check

ORDER OF REALIZATION

1. By the check the switch has to be withdrawn of the car (1 sees the paragraph, Substitution).
2. With the help or the cloth with samples of equipped embroidery of lamp of the existence of check of provision of individual power of the condutividade between the switch ties both of his provisions (to see the table I lower). In case of the necessity they substitute the switch.

Card of conditions of the switch of activation of a tempostat


POSITION OF THE SWITCH	EXISTENCE OF CONDUTIVIDADE BETWEEN CAPTURES
Incl. (In)
Civic	2 and 3
It integrates	1 and 2
(OF) (check of a lamp)
Civic	1 and 2; 4 and 5
It integrates	2 and 3; 4 and 5

Substitution

ORDER OF REALIZATION

1. Hook the switch up to small screwdriver and take it of the panel (companion sees an illustration). Disunite to electric capture.

2. The installation is done upside-down.

Switch of activation of heating from rear glass

To check

Card of conditions of the switch of activation of heating from rear glass (model of Full text)

ORDER OF REALIZATION

1. Withdraw the switch of the panel (1 sees down the paragraph, Substitution).

2. In the Civic models the chain of the switch lit the stopwatch that demands a special method of carrying out the control. In case of the violation of the usefulness of the functioning of a heater they include the ignition (they do not begin the motor), soon one to positive probe of a voltômetro to the capture of capture of braid of electrical system of switch n ° 1, one to negative probe to the capture n ° 4 (companion sees an illustration). The device will register the tension of battery, otherwise to check a condition of an electrical system and a lock of security of a chain.

3. If the tension of the battery happens, 1 and 4 establishes a point of passage of wire between number of captures n °. If now the heater works, substitute the switch, in the opposite check a condition of the alternation of a heater (to see the Alternation - the general information and the check of the usefulness of the functioning) with the corresponding chain.

4. In the Full text models through an ohmmeter or the cloth with samples of equipped embroidery of lamp of the existence of check of provision of individual power of the condutividade between captures of switch (companion and the table see an illustration I lower). In negative results of the check they substitute the switch.

Card of conditions of the switch of activation of heating from rear glass (model of Full text)

POSITION OF THE SWITCH	EXISTENCE OF CONDUTIVIDADE BETWEEN CAPTURES
Incl. (In)	4 and 6
(OF) (check of a lamp)	1 and 3; 2i 5

Substitution

ORDER OF REALIZATION

1. Having hooked the screwdriver up, exactly take the switch of the panel of the car (companion sees an illustration). Disunite to electric capture.

2. The installation is done upside-down.

Switch of lighting of the panel and current fires

To check

ORDER OF REALIZATION

1. Withdraw the switch of the panel of the car (1 sees down the paragraph, Substitution).
2. The chain of the switch included an outline of the management, therefore, the control happens for a special method. During the check each outline is tested in an individual order. If the usefulness of the functioning of the system is broken, nevertheless bad functioning in outlines the switch is not revealed, therefore, more probably it is damaged. check a condition of captures of the switch. In case of the necessity they smooth the put out rusty captures are straightened. In case of the necessity they substitute the switch.

3. An ohmmeter joins between the capture n ° 2 of the capture of a braid of an electrical system of the switch and the mass of the chassis (companion sees an illustration). The condutividade has to happen, otherwise to check a chain the interval and the confidence of the fixation of terminal connections.

4. In the included front lighthouses they join the voltômetro between the capture n ° 1 and I weigh. If the tension of the battery if it is going away, checks a condition of component ones of a chain in the siege to the block of meeting located below the panel and to the combined switch.
5. In the included front lighthouses they establish a point of passage of wire between the capture n ° 3 and the mass of the chassis. The lighting of the panel has to be joined in the very brilliance.
6. An electrical system that is joined as it is necessary to be, it substitutes the switch.

Substitution

ORDER OF REALIZATION

1. Having hooked exactly the screwdriver up, launch the switch of the panel of the car (companion sees an illustration). Disunite to electric capture.

2. The installation is done upside-down.