Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Check of usefulness of repair of recuperation and functioning of a heater from rear glass

The element of work of a heater from rear glass represents a horizontal trellis of the threads of driving glued in the internal glass surface. The food in a heater moves for a security lock for 30 one of the block of the distribution of the power located in a compartment of reason of the car. The inclusion of a heater is done through the switch located in the panel of the car. In the time of models of Full text of the continuous functioning of a heater it contents itself with the stopwatch that is lit in the built unity of control.

The small intervals of driving threads of a trellis of an element of work can be removed without they are demolished of the rear glass.

To check

ORDER OF REALIZATION

1. Include the ignition and a heater from rear glass.
2. Hold tight the positive probe of the voltômetro to the positive capture of a trellis of an element of heating, hold tight the negative probe to the negative capture. The device will register the tension of battery, otherwise to check a condition of a lock of security, the switch and an electrical system that is joined. If the tension is normal, nevertheless a part of the heater does not work. It passes to the next stage of the check.

3. To measure the tension during the checks described below of the wind the positive probe of the voltômetro with a metal metal leaf that is then easy what a finger will press straightly to the driving of the thread of a trellis of an element of heating (companion sees an illustration). Adhere to negative probe of the instrument of measuring to the negative capture of a trellis.

4. The measure tension in the central part of each one of threads of trellis (companion sees an illustration).

5. The indication in 5÷6 of V confirms the usefulness of a condition of the thread. The null indication talks about the existence of the interval between the center of the thread and a positive side of an element. Overestimate it of the indication two times (10÷12 of V) it happens in the presence of the interval between the center of the thread and a negative side of an element. In series check each one of threads of trellis.
6. The intervals absence they join the negative probe to the mass of the chassis and repeated check – the indications must not be modified, otherwise the violation of the quality of the base of a trellis happens.

7. Since the location of the interval holds tight the negative probe of the voltômetro to the negative capture of a trellis of an element of heating. The positive probe that is rolled up by a metal leaf begins to try threads of driving of a trellis, which moves of giving from the food to the weight. In an interval the reading instrument of point will reduce from several volts to the zero (companion sees an illustration).

Recuperation repair

ORDER OF REALIZATION

1. The restoration of the entirety of driving threads does through a special remnabor of the type n ° 4817 of Dupont to itself. The base of the play is made by the briefcase of epóxi from complete handed driving of a hardener.
2. Before the repair of initial recuperation of a trellis of an element of work they put a heater out and leave an element to us one abates inside several minutes.
3. Lightly smooth the damaged siege of the hurt thread, then carefully rub it with the alcohol.
4. Glue two strips from an insulating tape along the siege of the thread that is subject to the restoration.
5. Carefully mix the briefcase of epóxi with a hardener.

6. Apply the structure received in the damaged siege (with a superposition approximately in 20 mm in edges of the intact thread) (companion sees an illustration).

7. The final polymerism of a compound happens during 24 hours after which the protective strips from an insulating tape can be withdrawn of the glass.