Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Removal and installation of levers of a rear support of the triangular form of interruption

ORDER OF REALIZATION

1. Weaken nuts of the fixation of the corresponding wheel. A car behind also establishes it the Poddomkratta in stakes. Withdraw a wheel.

Superior lever

ORDER OF REALIZATION

1. Give a nut of one for the pin of the fixation of the superior lever of a support of the triangular form of interruption to the longitudinal lever (companion sees an illustration), takes a pin.

2. Result pins of a collar of the fixation of the basic capture of the internal end of the lever to the bottom of the car (to see an illustration in top). Withdraw the superior lever.
3. There checks the basic capture existence of slits, signs of hardening or aging of rubber. The incorrect capture is subject to a vypressovyvaniye and substitution – the work must be executed in the conditions of a workshop of the service of the car.
4. The installation is done upside-down. I respect of trace to the necessary efforts of corseting itself of the fixation.

Lower lever

ORDER OF REALIZATION

1. There results a pin of the fixation of the lowest lever to a longitudinal one, and also a pin of the fixation of the meeting that is loosened to the lowest lever (to see the Removal and the installation of the meeting of the absorbent one of the rear shock with a spring of screw).

2. Give a nut and take an axial pin of the fixation of the internal end of the lowest lever to the chassis of the car (companion sees an illustration). Withdraw the lowest lever.

3. Check that a condition of basic captures, in case of the necessity they do his substitution in the conditions of a workshop of the service of the car (the press is going to be needed).
4. The installation is done upside-down. I respect of trace to the necessary efforts of corseting itself of the fixation.

Compensation lever

ORDER OF REALIZATION

1. There results a pin of the fixation of the lever of compensation to a longitudinal one (companion sees an illustration).

2. Give a nut of one for the pin of the fixation of the lever of compensation to the bottom of the car (to see an illustration in top). Take a pin and withdraw the lever of compensation.
3. Check that a condition of basic captures, in case of the necessity they do his substitution in the conditions of a workshop of the service of the car (the press is going to be needed).
4. The installation is done upside-down. I respect of trace to the necessary efforts of corseting itself of the fixation.

Longitudinal lever

ORDER OF REALIZATION

1. Desconecte a hydraulic hose of the cylinder of wheel / a rear support. At the same time to a zakuporta the open ends of a hose and the union to avoid the blow in the system of the dirt. Withdraw the drum of brake and meeting of shoe. In models with mechanisms of brake of disc of back the wheels withdraw a support and a disc of brake. Desconecte a thread of the walk of the brake of parking of the executive lever (the Head sees the System of brakes).
2. Withdraw a council of the mechanism of brake.
3. Desconecte of the longitudinal lever of the meeting of the top, more low and compensation levers (to see in top).

4th. Launch a thread of the walk of the brake of parking of an arm in the meeting of the longitudinal lever. Result pins of the fixation of an axle of the basic capture of the longitudinal lever to the bottom of the car and withdraw the lever (companions see illustrations): left fixation pin.

4b. I set pins straight of fixation.

5. Check that a condition of basic captures, in case of the necessity they do his substitution in the conditions of a workshop of the service of the car (the press is going to be needed).
6. The installation is done upside-down. I respect of trace to the necessary efforts of corseting itself of the fixation.