Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Removal and installation of a steering-wheel

Removal

Considered in the present manual of the car they are equipped of cushions of security (men). When there are executing any work near to sensors of punches, a column of direction or the panel desconectam men (to see schemes of electric connections in the end of the electric equipment of Front Side).

ORDER OF REALIZATION

1. Desconecte of the battery in the beginning a negative wire, then positive. If the stereosystem established in the car if it equips of a security code before desconectar the battery they secure what has the correct combination of the entry of the system sound in the action! 2nd. Spin a steering-wheel in 180 ° so that the covering of the access to his internal part appeared in top. To discover. 2b. Of his internal party the point of passage of capture destined for an immobilization of module of cushion of security concentrates. 2c. Take the capture of an armband in a covering (companion sees an illustration). 2nd. Disunite color yellows the capture of the unsteady movement of end of the module SRS and they install the point of passage of capture to the place of his capture, having immobilized temporarily through that the module of cushion of security. 3rd. Result both screws with heads like TORX of the party of meeting of a steering-wheel spun to the panel (companions see illustrations). 3b. These screws in the meeting fixed the module MR. 4. Withdraw the module of the meeting of a steering-wheel and remove it to the safe place, having stored a front surface. Try not to turn the module to face to you. Do not put from above in the module any foreign object in absolute. 5. Electric taken Disunite of the button of a horn and (in the corresponding complete set) a tempostata. 6. Give a nut of the fixation of a steering-wheel. Having withdrawn a nut, mark the provision of a nave of a steering-wheel about an end of column (companion sees an illustration). 7. Having pulled a strictly parallel wheel to the axle, withdraw it of a direction end. If the wheel does not hand, some of his poraskachivayta. Do not allow the rotation of an end of a column in the withdrawn steering-wheel as it can drive to the damage of the unsteady movement of end of the module MR.

Installation

ORDER OF REALIZATION

1. One secures that the advanced wheels of the car if they develop in the right-lined situation. 2. It is secured what the arrow with the marking of TORAHS of the unsteady movement of thread SRS specifies strictly (companion sees an illustration), – if the column axle after the removal of a steering-wheel did not make revolving with this question there must not be problems. If for some reason the end however turned, make centering, working how if it follows:    a) The unsteady movement of end turns against the stop in the direction of the movement of the pointers of the clock;    b) Turn the unsteady movement of end in reverse sense to the movement of the pointers of the clock approximately in two turns for which the yellow tooth of a wheel of gear if it was going together with an etiquette in a covering (it treats only some models), and the marking of "TORAHS" appeared in top. 3. Bring a steering-wheel to the regular situation and carry out the combination of the etiquettes of landing put in the course of they are demolished (6 sees the paragraph, Removal). One secures that the pins of direction of a column come to reciprocal openings of a reverse side of a steering-wheel. Put a nave of wheel in a pin of an end of direction, screw a nut of fixation and hold tight it with the necessary effort. 4. One taken of a horn and (in the corresponding complete set) a tempostata. 5. Install at the place the module SRS, having fixed it for new screws of TORX. The trace that the screws corseted themselves with the necessary effort. Establish to the place of a covering of the access the screws. 6. Take the point of passage of capture. 7. Join together halves of the capture of the unsteady movement of thread MR. 8. Bolt the point of passage of capture in an armband of a reverse side of a covering of the access and establish the last thing in the meeting of a steering-wheel.