Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Substitution of the absorbent one of the shock or spring of screw of meeting for assembly in rack of an advanced support of the triangular form of interruption

ORDER OF REALIZATION

1. Withdraw the meeting that is loosened of the car (to see the Removal and the installation of the meeting of the absorbent one of the shock advanced with a spring of screw or Removal and the installation of the meeting of the absorbent one of the rear shock with a spring of screw).
2. Check the absorbent of the shock to existence of signs of holes, dents, slits and other mechanical damages. Examine a spring of screw in the existence of chips, slits, signs of flash of lightning and pillows of rubber of his support in the existence of signs of hardening and aging of the material. In centers of services of the company of Honda it is always possible to buy absorbent from the shock joined with springs of screw in an exchange base that there allows to reduce the time and the monetary expense significantly. In view of the saying before beginning the desmontagem of the absorbent one of the shock for aims of executing his repairs of capital they execute to sell, having defined in the prices of replaceable component ones and having compared them with prices of the acquisition of the restored meeting.

The screw spring removal of moistening the meeting is joined with the potential danger and has to be done only with the use of the special instrument of high quality.

3. Meeting of armband of the absorbent one of the shock in a vice with gentle sponges (done not not exaggerated strongly).
4. Mark the provision of the base of a support regarding one spring (if the spring is substituted, then regarding the meeting that is loosened).

5. The next educations of the manufacturers, install the instrument to corset itself of a spring of screw. When nuts are insisting on hair clips of hair of instrument (companion seeing an illustration), hold tight one spring so completely to unload the base of support.

6. Withdraw a protective hat and the самоконтрящуюся gives a nut (companion sees an illustration), when a key is maintaining a stick of damper of a provorachivaniye prutkovy. Withdraw component of the superior support of the absorbent one of the shock, having spread them in a pure surface it is strict like an agreement of the meeting.

7. Carefully withdraw the pressed spring of screw of the meeting and remove it to the safe place.

One does not develop the pressed faces of spring end!

8. Withdraw the remained component ones of a stick of damper and spread them in a bank (like installation in the meeting).
9. Readjust in the new deadening meeting the buffer of return with the plate, a covering on trial of powder and his plate. Spread a stick of a damper out in the whole length of his course and pass it over the installed component ones.
10. Exactly put the meeting of pressed spring of screw. Fairness of trace of landing of the face of end more decrease of one spring in the saddle.
11. Establish a pillow of rubber of a saddle of one spring, the capture of support of stick to base of support of meeting, a lavador of a nut of fixation and new самоконтрящуюся a nut. Before holding tight a fairness of trace of nut of the combination of the etiquettes put in the course of they are demolished.
12. Property of a stick of a provorachivaniye a key prutkovy, hold tight самоконтрящуюся a nut with the necessary effort. Launch the instrument of the compression of one spring and withdraw it of the meeting. Establish a protective hat.
13. The meeting begins at the regular place and install in the car (to see the Removal and the installation of the meeting of the absorbent one of the shock advanced with a spring of screw or Removal and the installation of the meeting of the absorbent one of the rear shock with a spring of screw).