Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Honda Tsivik
+ Cars of the mark of It Treats Full text and Honda Civic With care
+ Maintenance education
+ Regular maintenance
+ Motor
+ Cooling of system and heating
+ System of provision of power and launch
- Electric motor equipment
   Specifications
   Launch of the motor of the provision of being able to help
   Check of a state and substitution of the battery
   Check of a state and substitution of wires of the battery
   Ignition system - the general information
   Check of functioning of system of ignition
   Check of a state and substitution of the roll of ignition
   Check of usefulness of functioning and substitution of the module of management of ignition (VAT)
   Removal and installation of the distributor of ignition
   Check of installation and agreement of a corner of an advancement of ignition
   System of a load - the information general and measured by precaution
   Check of a condition of system of a load
   Removal and installation of the creator
   Substitution of the regulator of tension and brushes of the creator
   Departure system - the information general and measured by precaution
   Check of usefulness of functioning of an author in the car (in situ)
   Removal and installation of an author
   Removal and installation of the alternation of traction
+ Systems of control of the motor
+ Box of dislocation of gear
+ Union and ends of power
+ Brakes system
+ Support of the triangular form of interruption and direction
+ Body
+ Electric side equipment

Substitution of the regulator of tension and brushes of the creator

In all the Civic models and some models of Full text of 1998 of the creators of question of the production of Mitsubishi to company they are in use. The substitution of brushes and the regulator of the tension demand the desmontagem full of the creator here and have to be accused to specialists of the service of the car.

The substitution of brushes and the regulator of the tension in creators of Nippondenso can be done by force itself of the amateur mechanic, nevertheless it is not necessary to do attempts of the realization independent of the complete repair of recuperation of the creator. It will be more simple to substitute the meeting.

ORDER OF REALIZATION

1. Remove the creator of the car (to see the Removal and the installation of the creator) and transfers it to a bank.

2. Give three nuts of fixation and withdraw a rear cape of the creator (companion sees an illustration).

3. Give two screws of the fixation of the bearer of brush (companion sees an illustration).

4. Remove the bearer of brush of a rear face of end of the creator.

5. The length of measure of a vystupaniye of each one of brushes of the bearer (companion sees an illustration) and it compares when they resulted from measurements to Specifications demands. If the size of a vystupaniye of brushes will be tied less than more low than the admissible variety, it does his substitution.

6. Check the freedom of the course of brushes in the cartridges of the bearer.

7. For the substitution of the regulator of the tension it is necessary to withdraw the meeting of the bearer of brush previously. Then give screws of fixation (companion sees an illustration) and withdraw the regulator of the creator.

8. The installation is done upside-down. During the installation to the place of the brush the bearer they pull out brushes of a transmission of end to small screwdriver.