Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car



Honda Tsivik
+ Cars of the mark of It Treats Full text and Honda Civic With care
+ Maintenance education
+ Regular maintenance
+ Motor
+ Cooling of system and heating
+ System of provision of power and launch
- Electric motor equipment
   Specifications
   Launch of the motor of the provision of being able to help
   Check of a state and substitution of the battery
   Check of a state and substitution of wires of the battery
   Ignition system - the general information
   Check of functioning of system of ignition
   Check of a state and substitution of the roll of ignition
   Check of usefulness of functioning and substitution of the module of management of ignition (VAT)
   Removal and installation of the distributor of ignition
   Check of installation and agreement of a corner of an advancement of ignition
   System of a load - the information general and measured by precaution
   Check of a condition of system of a load
   Removal and installation of the creator
   Substitution of the regulator of tension and brushes of the creator
   Departure system - the information general and measured by precaution
   Check of usefulness of functioning of an author in the car (in situ)
   Removal and installation of an author
   Removal and installation of the alternation of traction
+ Systems of control of the motor
+ Box of dislocation of gear
+ Union and ends of power
+ Brakes system
+ Support of the triangular form of interruption and direction
+ Body
+ Electric side equipment


5dfc58ab

Check of a state and substitution of the roll of ignition

 To check

 ORDER OF REALIZATION

1. Put out the ignition (the key has to be turned in the position of).
2. Withdraw of the distributor a covering, the corridor and the filter (in the corresponding complete set).
3. Electric taken Disunite of primary outline of the roll of ignition.

4th. Through a measure resistance of ohmmeter between captures (And yes in) the primary curve of the roll (companions see illustrations).

4b. Measurement of resistance of primary curve of the roll of ignition in models with the distributor TES. Compare the result of the measurement to Specifications demands.

5th. Then measure the resistance between the positive capture of the primary curve (A) and the capture of a secondary curve (I model with the distributor of Hitachi). Again compare the result with Specifications demands.

5b. Measure resistance between the positive capture of primary curve (A) and the capture of a secondary curve (I model with the distributor TEC).

6. Remember that the values standard of the resistance of windings are modified with a temperature. The values of the temperature of the roll of 21 °C happen in Specifications.
7. If in some of two last checks the result of the measurement exceeds the limit of the admissible variety, substitute the roll of ignition.

Substitution

 ORDER OF REALIZATION

1. Desconecte a negative wire of the battery.

If the stereosystem established in the car if it equips of a security code before desconectar the battery they secure what has the correct combination of the entry of the system sound in the action!


2. Withdraw of the distributor a covering and the filter (in the corresponding complete set) (to see the Front Regular maintenance). Desconecte wires of captures of the primary outline of the roll.

3. Result two screws of fixation (companion sees an illustration) and take the roll of ignition of the meeting of the distributor.

4. The installation is done upside-down.