Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Check of a state and substitution of the battery

To check

ORDER OF REALIZATION

1. Desconecte both wires of the battery. The negative wire always has of desconectar-se first of all and to be joined in the last one. If the stereosystem established in the car if it equips of a security code before desconectar the battery they secure what has the correct combination of the introduction of the equipment to the action! 2. Check the level of eletrólito in the battery (only it concerns when the batteries service that needs) were equipped of removable coverings – the eletrólito has to hide completely lamels, otherwise in banks that the corresponding amount of the distilled water follows. DO NOT FLOW, – the excess of the eletrólito in the excessive battery which snake will begin flooding mouths! Through the areometer (they ask in shops of motor accessories) they measure the specific weight of the eletrólito (companion sees an illustration). Discover thickened mouths and take the test of eletrólito areometer in series of each one of cans of battery. The next educations of the manufacturers, determine the specific weight of the eletrólito for the provision of a buoy of measuring of the device. At the normal level of a load the specific weight of the eletrólito will do 1,270 unities (a green zone of a scale of measuring). In the excessively low density of the eletrólito (a red zone of a scale) the battery must be accused (to see the Front Regular maintenance). The tension of production of the battery will do 12.6 B or will be lightly higher. The nominal tariff of the density of the eletrólito is defined depending on the room temperature (and it is straightly proportional to him) – they use the map of temperatures handed by manufacturers in a play to the battery. 3. The most right control of a condition of the battery can happen through the instrument of measuring universal (ask in shops of motor accessories). The device allows to define the capacity of the battery to a provoachivaniye of an author and the offer of the food to consumers of side of the electric power in the lifted loads of the motor. Join the instrument of measuring to captures of battery (companion to see an illustration). Follow the manufacturers' educations of the device – in the moment of the inclusion of 15 seconds to load the tension of the battery they must not fall down, of what to value 9.6 B, otherwise the battery has to be substituted. In room temperatures below of 0 °C the least admissible indication reduces up to 9.1 century.

Substitution

ORDER OF REALIZATION

1. Desconecte both wires of the battery. The negative wire always has of desconectar-se first of all and to be joined in the last one. If the stereosystem established in the car if it equips of a security code before desconectar the battery they secure what has the correct combination of the introduction of the equipment to the action! 2. The launch fixation and it withdraws a level of pressure of the fixation of the battery in the trundle bed (companion sees an illustration). 3. Withdraw the battery of the trundle bed (companion sees an illustration). The special supports of triangular form for the doorknob are given out. The use of such a support of triangular form significantly simplifies the proceeding of the extraction of the battery of a compartment of reason. 4. Withdraw the trundle bed and attentively examine it in the existence of aspects of the corrosion. 5. In case of the necessity they withdraw a support of trundle bed for his ends of the removal of products of corrosion of bass and the work from corresponding protective metal (use escorvadores in a zinc base). 6. Substituting the trace that the replaceable battery adjusted according to the characteristics with demands of his car. 7. The installation is done upside-down.