Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car


Honda Tsivik
+ Cars of the mark of It Treats Full text and Honda Civic With care
+ Maintenance education
+ Regular maintenance
+ Motor
+ Cooling of system and heating
+ System of provision of power and launch
- Electric motor equipment
   Specifications
   Launch of the motor of the provision of being able to help
   Check of a state and substitution of the battery
   Check of a state and substitution of wires of the battery
   Ignition system - the general information
   Check of functioning of system of ignition
   Check of a state and substitution of the roll of ignition
   Check of usefulness of functioning and substitution of the module of management of ignition (VAT)
   Removal and installation of the distributor of ignition
   Check of installation and agreement of a corner of an advancement of ignition
   System of a load - the information general and measured by precaution
   Check of a condition of system of a load
   Removal and installation of the creator
   Substitution of the regulator of tension and brushes of the creator
   Departure system - the information general and measured by precaution
   Check of usefulness of functioning of an author in the car (in situ)
   Removal and installation of an author
   Removal and installation of the alternation of traction
+ Systems of control of the motor
+ Box of dislocation of gear
+ Union and ends of power
+ Brakes system
+ Support of the triangular form of interruption and direction
+ Body
+ Electric side equipment


5dfc58ab

Check of a state and substitution of wires of the battery

 ORDER OF REALIZATION

1. Regularly examine wires of battery in the whole his length in the existence of damages, slits and progar of the isolation, and also corrosion aspects. One does not forget of that the violation of the quality of the electric connection of captures of contact is able to lead to difficulties in the launch of the motor, and also to lessen in the efficiency of his return.

2nd. Check terminal clips of wires (companions see illustrations) for existence of slits, losses of veins of copper and aspects of the corrosion. The presence accumulated below the layer of isolation near to terminal hints of white powdered deposits talks about development of the corrosion and necessity of the substitution of a wire. Check when they were taken of the battery and clips of the fixation of hints of wires for them in existence of signs of the deformation, weakening of pins and aspects of the corrosion.

2b. The lowest end of a negative wire of the battery is annexed to the metal of hoof of the car.

2 pages. In the Full text models the basic tire that joins the motor to a body is in use.

2nd. The wires of the battery have to concentrate on total supplied intermediary armbands.

3. The negative wire if desconecta of the battery first of all and one always adheres in the last one. Do not forget of desconectar a negative wire even in case of which only a positive is subject to the substitution.
4. Take the wire that is subject to the substitution with you in the shop like an example. The extremely important factor is the complaisance of a drawing of clips of a wire to the form of joining captures in the car.

If the stereosystem established in the car if it equips of a security code before desconectar the battery they secure what has the correct combination of the introduction of the equipment to the action!


5. Desconecte of the battery old wires (in the first negation), soon "walks" in each one of them up to the opposite end and desconecte of the alternation of traction of an author (positive) and captures of establishing (negative). Try they remember roads of the placing of both wires for aims of the observance during the installation again.

It is easy one of other distinguishes wires in the color of the isolation, always black in negative and red in the positive. Besides, the positive wire normally has the biggest section.


6. A wire brush smooths a woodcarving in captures they are joined of the alternation of traction and base. After the removal of all the aspects of the corrosion lightly they polish circles of woodcarving with the free acid vaseline for aims of the prevention of the development of the corrosion besides that.
7. Join a wire to the capture of the alternation / weight of traction and strongly hold tight a nut of fixation / pin.
8. Before a new wire adheres to the capture of the battery they secure what freely gets it without excessive tension. Carefully smooth when they were taken of battery, then lightly polish them with the free acid vaseline.
9. First of all a positive wire always adheres to the battery, then negatively.