Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Agreement and substitution of the switch of sensor of position of the lever of the selector of transfers

To check

Considered in the present manual of the car they are equipped of cushions of security (men). When there are executing any work near to sensors of punches, a column of direction or the panel desconectam men (to see schemes of electric connections in the end of the electric equipment of Front Side).

ORDER OF REALIZATION

1. Withdraw the consolation (to see the Chief Kuzov). 2nd. Disunite to electric capture of 14 contacts of the switch of sensor of the position of the lever of a selector (companions see illustrations): civic models. 2b. Models of Full text. 3. Check that the switch of sensor of the complaisance of conditions of the sensor takes notice of cards of the condutividade (companions see illustrations). It transfers the selector's lever in series to each one of provisions, without touching the button of press. Remember that it will turn the size of free one of the lever in each one of provisions it does approximately 2 mm. In negative results of the check they do the agreement of the switch of sensor (see down). Card of condutividade of the switch of sensor of position of the lever of the selector (civic Model) 1 - 7 — the switch of Sensor of position of the lever 3 - 4 — the switch of Sensor of fires of a support 10 - 11 — the switch of Sensor of permission of departure * — Tempostat The card of condutividade of the switch of sensor of position of the lever of the selector (the Full text model to model without tempostat) One — L — the switch of Sensor of position of the lever (I model without tempostat) With — D — the switch of Sensor of fires of a support J - K — the switch of Sensor of permission of departure

Agreement

ORDER OF REALIZATION

1. Transfer the selector's lever to the situation "P" and weaken nuts of the fixation of the switch of sensor (to see an illustration I lower). 2. Move the lever towards the situation "D" so that the condutividade between captures 2 and 14 Civic/A and L (Full text) of the capture of the switch of sensor it appeared. The condutividade will remain inside free to go round of the lever (approximately 2 mm). 3. Carry out the control described in the paragraph 3 (Check) is higher. One secures that the motor is begun in the position "N" of the lever. 4. If the demands of the card of provodimost brisk persons still remain, check a condition of an armband and an arm of the lever of the selector. If it is not possible to reveal any damage, substitute the switch of sensor.

Substitution

ORDER OF REALIZATION

1. Withdraw the consolation (to see the Chief Kuzov). 2. Disunite the capture 14-kontatkny of the sensor switch (to see illustrations in top). 3. Give two nuts of fixation (companion sees an illustration), withdraws lavadores. Withdraw the switch of sensor. 4. Transfer the sheep of the new switch of sensor to the neutral situation (situation "N"). 5. Transfer the selector's lever to the situation "N" and install the new switch of sensor. 6. Put lavadores and fix the switch of sensor for nuts. 7. 3 (Check) carries out the control of the switch of sensor according to the educations supplied in the paragraph. One secures that the motor is begun in the position "N" of the lever of the selector. 8. Adhere to electric capture of the switch of sensor. Fix a braid of electrical system in total supplied armbands. 9. Install at the place the consolation (to see the Chief Kuzov).