Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Diagnostic of failure of em/CVT – the general information

Primary checks

ORDER OF REALIZATION

1. Heat the transmission up to the temperature of normal work during a short travel. 2. Check the level ATF (to see the Front Regular maintenance):    a) If the liquid is obviously not enough, do the corresponding agreement, having added the necessary quantity ATF it is more fresh. Be convinced about the fairness of the agreement transported out according to the indications of the probe of measuring, soon check the transmission to existence of signs of extern holes (see down);    b) If the level is too loudly, the excess of fusion of ATF, then the aspects existence checks it of cooling the liquid, the violation of testification of the tension of the internal splitting of an electric heater that separates his conductor of heat of tanks of side with ATF (to see the Head of the system of Cooling and heating);    c) If the foams ATF, the empty transmission and they fill it of the fresh liquid, – fused check of the existence of aspects of cooling the liquid. 3. Check the installation of turns of wasting time of the motor. If I do not eat the motor it must be, it will not be necessary to begin the realization of primary checks of the transmission until the corresponding corrections are done. 4. Check that the freedom of movement of a thread of driving of the management of a valve of butterfly in the kick way is lowered by me (model of Full text), in case of the necessity they do the corresponding agreement (to see the Agreement of seats). The thread prune officials it in normally in the coldness was killed by the motor that is not a guarantee of the usefulness of his action in the unity work and heated up to the temperature of normal work. Carry out the control of a thread in several conditions of the motor. 5. Check the sketch of a thread of the dislocation of gear (to see the Equipment and administrations in the hall), is secured of fairness of the agreement and freedom of his movement.

Diagnostic of leaks of ATF

ORDER OF REALIZATION

1. Most of holes easily are defined by the visual check. The repair normally is composed in the substitution of an incorrect epiploon or placing. If it will not get the hole to reveal a fountain during the visual inquiry, to act how if it describes down. 2. First of all it is necessary to exclude the probability of a mistake in the definition of the nature of the hole. It is not necessary to confuse ATF to the oil of reason or fluid of brake (the transmission liquid normally has the color dark-red). 3. Since the identification of a fountain of hole does I tan (several kilometers) a travel, soon it parks the car on the leaf of blank space of expansion of a card. Then a couple of minutes to fountain of hole can be revealed following to the liquid that drips in a card. 4. Attentively examine the suspected siege and the surface that goes round it, when there is paying the special attention an union of the inter-connected surfaces of in favor freemasonry. For aims of the expansion of an observation an angle they use a mirror of pocket. 5. If it is not possible to reveal a fountain of hole Meantime, carefully to rub the surface of the siege suspected with the rags moistened with the solvent, soon to dry it. 6. Make short travel one more, this time very often modifying the speed of the movement, then again examine the cleaned suspected siege. 7. After the identification of a fountain of hole, it is necessary to define and to withdraw the cause of his development, only soon to pass to the realization of the necessary work of recuperation. The substitution of the placing will not turn in the desirable result if it leaves when the defect of the inter-connected surface that led to his exit out of the operation was not removed. 8. In the next subsections the most typical reasons of the development of leaks of ATF and a condition that they have to carry out that there was no repetition are enumerated. The part of the enumerated conditions cannot be observed without the use of the special equipment. In this case the car must be expelled in the workshop of repairs of the car.

In favor freemasonry surfaces

ORDER OF REALIZATION

1. Periodicamente examines a covering in the right side of a case of transmission. Check the existence at the places and the confidence of the pressure of fixing pins, it looks what in a few aspects of covering of mechanical damages did not appear. 2. For coverings that excessively very much corset themselves of fixing pins, damage of a surface of fighter of a case of the transmission, putting the destruction, and also the emergence of slits or the porosity of walls of a case are between the possible reasons of the development of holes. There puts itself of a covering or the case of the transmission they if are formed by a pillow of selante, the probability of the incorrect choice of the type of the last one is not excluded.

Epiploons and fists of sleeve

ORDER OF REALIZATION

1. The most typical reasons of an exit of epiploons of the transmission level excessively tall ATF, violation of passability of a ventilation sapun, the mechanical damage of walls of a nest of landing, the damage in fact out of the operation is between an epiploon or incorrect installation of the last one. Also the probability of the damage of a pin of the end passed in all the parts of an epiploon, or a play of excessive side of the last one as a consequence of the loads use is not excluded. 2. Check a state and the fairness of the landing of a fist of sleeve of fighter of the tube of direction of the probe of measuring. Periodicamente examines in the existence of signs of holes a surface around an agreement of a wheel of gear of driving of a speedometer or the sensor of the speed (VSS). In case of the necessity it does the substitution of a ring of fighter.

Case of transmission

ORDER OF REALIZATION

1. The slits formation or a time in a body of case of transmission can be the reason of the development of leaks of ATF. be consulted with specialists of the service of the car. 2. Check knot tension of nipple of the connection of hoses of a fridge of ATF.

Sapun and thickened mouth

The holes for сапун or a gooey mouth they can happen due to the excessive stuffing of the transmission, hit ATF of cooling the liquid, the violation of passability of a sapun or repayable openings.