Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car



Honda Tsivik
+ Cars of the mark of It Treats Full text and Honda Civic With care
+ Maintenance education
+ Regular maintenance
+ Motor
+ Cooling of system and heating
+ System of provision of power and launch
+ Electric motor equipment
+ Systems of control of the motor
- Box of dislocation of gear
   + Manual box organized 5 of dislocation of gear
   - Automatic exchanges organized 4 and stepless (ат and CVT)
      General information
      Diagnostic of failure of em/CVT - the general information
      Check and adjust of a thread of management of a valve of butterfly in the kick way I lower (thread of TV) - the models of Full text
      Substitution and agreement of a thread of dislocation of gear
      Agreement and substitution of the switch of sensor of position of the lever of the selector of transfers
      System of blockade - the general information, check of a state, substitution and agreement of an eletroímã of management
      Check and substitution of valves eletromagnéticas of blockade management
      Removal and installation of automatic exchanges organized 4 and stepless (in and CVT)
+ Union and ends of power
+ Brakes system
+ Support of the triangular form of interruption and direction
+ Body
+ Electric side equipment


5dfc58ab

System of blockade – the general information, check of a state, substitution and agreement of an eletroímã of management

Considered in the present manual of the car they are equipped of cushions of security (men). When there are executing any work near to sensors of punches, a column of direction or the panel desconectam men (to see schemes of electric connections in the end of the electric equipment of Front Side).

General information

In all the equipped NW models system of blockading the prevention of the inadvertent switchings of the box is supplied. The system of the blockade is composed of two subsystems: systems of blockade of dislocation of gear and system of blockade of a key.

System of blockade of a key

The system prevents a possibility of the extraction of a key of the lock of ignition until the lever of the selector is not transferred to the situation "P". In the introduction of a key to the lock in excellent someone of the position "Р" of the lever there is an activation of the extraction of creation of mechanism of actuation eletromagnética of a key impossible one. To take a key, transfer the lever to the situation it demanded ("Р").

System of blockade of dislocation of gear

The system prevents a possibility of the translation of the lever of the selector of the situation "P" in the provisions "R" or "D" without squeezing of a pedal of a brake of foot. To blockade joinings also in the moment of squeezing simultaneous one of pedals of a brake and gas pedal. In case of refusal systems the lever can desbloquear-se for the introduction of a key to a special groove near to the lever meeting.

To check

The controls of mechanisms of actuation eletromagnéticos of ambo the blockade given below of the can happen of necessity itself of the amateur mechanic in house conditions. The most detailed diagnostic one of the system has to be executed in the conditions of a workshop of the service of the car.

Actuation mechanism eletromagnético of blockade of the key of ignition

 ORDER OF REALIZATION

1. Withdraw the lowest section of the finish of the panel and an emphasis of knee (to see the Chief Kuzov).

2. Disunite the capture of 7 contacts of the main braid of an electrical system (companion sees an illustration).

3. Check that the capture of the existence of the condutividade between league several provisions of the switch of the ignition. In a key utaplivaniye in the lock condutividade 5, 6 and 7 has to happen between captures. In a key otpuskaniye – between captures 5 and 6 (approximately 15÷20 of Ohm in the last case).
4. One secures that the extraction of a key is not possible when 5 and 7 are giving the tension of the battery in captures.
5. If the key is not taken, therefore the system of blockading functions regularly, otherwise it is necessary to substitute the meeting of the lock of the ignition (the locks in an individual order are not given out).

Actuation mechanism eletromagnético of blockade of dislocation of gear

 ORDER OF REALIZATION

1. Withdraw the consolation (to see the Chief Kuzov).

2. Disunite the capture of 2 contacts of the device eletromagnético of the blockade of the dislocation of gear (companion sees an illustration).

3. Through two points of passage of wires for a moment they join the battery to taken of capture (a safe pole – to the capture 1, negative – to the capture 2) and auricularmente they make sure of the usefulness of the operation of the lock.

The violation of the polarity of the connection of the battery is loaded of the failure of the diode in the meeting eletromagnética.


   a) If it does not follow the click, substitute the knot eletromagnético;
   b) If the device works normally, nevertheless the problems with the blockade remain, it is necessary to try to do the agreement (see down).
4. In the device eletromagnético connected they measure the size of slit between the lever of blockade and the dredging of a finger of lock (see down).
5. In the device eletromagnético off they secure of the fixation of a finger of lock the lever of blockade. If the finger is not blockaded, do the agreement of the device eletromagnético (see down).

Substitution and agreement of the mechanism of actuation eletromagnético

Described I lower the proceeding only it is made a list to the lock of dislocation of gear. The information on the substitution of the mechanism of actuation eletromagnético of the blockade of the key of ignition is supplied in the Section devoted to the substitution of the cylinder of the lock of the ignition (to see the electric equipment of Front Side).


 ORDER OF REALIZATION

1. Withdraw the capture of blockade and a finger of the device eletromagnético.
2. Give nuts самоконтрящиеся and withdraw the device eletromagnético of the blockade of the dislocation of gear.

The nuts are subject to the substitution without fail.


3. The installation is done upside-down. Do not hold tight new nuts finally until they carry out the agreement of the device eletromagnético (to see besides that).

4. Since the agreement of the mechanism of actuation eletromagnético of the blockade of the dislocation of gear gives in him the food and measures a slit between the lever of blockade and the dredging of a finger of lock (companion sees an illustration). Compare when they resulted from the measurement to Specifications demands. In case of the necessity they adjust a slit updating of the provision of the device eletromagnético, then finally they hold tight nuts самоконтрящиеся of his fixation with the necessary effort.


Do not forget of substituting nuts самоконтрящиеся.


5. One secures that on the device eletromagnético off the lock finger concentrates for the lever of blockade (companion sees an illustration). If the finger is not blockaded, repeat the agreement of the position of the device eletromagnético.