Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Removal and installation of the main cylinder of union

Removal

ORDER OF REALIZATION

1. Desconecte a negative wire of the battery. If the stereosystem established in the car if it equips of a security code before desconectar the battery they secure what has the correct combination of the entry of the system sound in the action! 2. Below the panel they take a pin and desconectam a finger that cuts of an empurrador of the main hydraulic cylinder of a pedal of union. 3rd. Desconecte the tank of the main cylinder of the union (companion sees an illustration). 3b. The claws of Самоконтрящимися hold tight the hose of offer that joins the tank to the main cylinder (companion sees an illustration). Hose is necessary there insist on the distance approximately 5 cm of the stiff cylinder of reduction in the union. 4. Desconecte of the main cylinder hydraulic lines (companion sees an illustration). For aims of the reduction to the minimum of losses of the hydraulic liquid wind the nipple ties with knot with rags. At the same time to a zakuporta the open ends of lines and unions to avoid the blow in the system of the dirt. To avoid that the damage of a painting and covering of varnish does not allow the blow of hydraulic liquid in the painted surfaces of lists of body. 5. In the interior of the car below the panel they give two nuts of the fixation of the main cylinder to a splitting of a compartment of reason (companion sees an illustration). Withdraw the cylinder of the car.

Installation

ORDER OF REALIZATION

1. The main cylinder begins at the regular place and fix for pins, what have for the hand it held tight nuts of the last one. 2. Restore the initial connection of hydraulic lines. In case of the necessity the lightly correct position of the cylinder for aims of the simplification of a nazhivleniye of the union of the pressure they head the line. Hold tight a collar of the fixation of the hose of offer. 3. Strongly hold tight the fixation and the union of the hydraulic line. 4. Join an empurrador to a pedal of the union and there registers a new pin a finger that cuts. 5. Withdraw the claws that hold tight the hose of offer. Fill out in the tank the necessary amount of the fluid of brake of the POINT 3 (to see the Front Regular maintenance), soon gives of a few traffic jams of air traffic of way (to see the Removal of air of a hydraulic way of the walk of the extinguishment of the union).