Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car


Honda Tsivik
+ Cars of the mark of It Treats Full text and Honda Civic With care
+ Maintenance education
+ Regular maintenance
+ Motor
+ Cooling of system and heating
+ System of provision of power and launch
+ Electric motor equipment
+ Systems of control of the motor
+ Box of dislocation of gear
- Union and ends of power
   Specifications
   Union - the general information and check of a condition of component ones
   Removal and installation of the main cylinder of union
   Removal and installation of the executive cylinder of union
   Removal of air of a hydraulic way of the walk of extinguishment of union
   Removal, check of a state and installation of component ones of meeting of union
   Check of a state and substitution of the load of direction
   Removal, check of a state and installation of the load of launch and fork of extinguishment of union
   Agreement of a pedal of union
   Check of a state, substitution and agreement of the switch of sensor of disconnection of a chain of an author
   Removal and installation of ends of power
   Removal and installation of an intermediary end (model of Full text)
   Substitution of protective coverings and check of a condition of UNIONS of HP
+ Brakes system
+ Support of the triangular form of interruption and direction
+ Body
+ Electric side equipment


5dfc58ab

Removal and installation of the executive cylinder of union

Removal

 ORDER OF REALIZATION

1. Desconecte a negative wire of the battery.

If the stereosystem established in the car if it equips of a security code before desconectar the battery they secure what has the correct combination of the entry of the system sound in the action!


2. The car also establishes it the Poddomkratta in stakes.

3. A key of special hat weakens a nut of nipple and desconecta of the executive cylinder the hydraulic line (companion sees an illustration). Be prepared to join the spilled liquid. At the same time to a zakuporta the open ends of the line and connection of nipple to avoid the blow in the system of the dirt.

4. Result two pins of fixation (companion sees an illustration).

5. Withdraw the executive cylinder.

Installation

 ORDER OF REALIZATION

1. Install the executive cylinder at the regular place in an union dome, to the hand hold tight pins of fixation. Fairness of trace of landing of an empurrador in an union that puts pocket of fork out.
2. Adhere to hydraulic line to the cylinder, then finally hold tight pins of fixation. A key of special hat strongly holds tight a nut of nipple.
3. Fill out the necessary amount of the fluid of brake of the POINT 3 in the cylinder.
4. Pump on the hydraulic system (to see the Removal of air of a hydraulic way of the walk of the extinguishment of the union).
5. Lower the car in the land and a negative wire adheres to the battery.