Honda Tsivik
+ Cars of the mark of It Treats Full text and Honda Civic With care
+ Maintenance education
+ Regular maintenance
+ Motor
+ Cooling of system and heating
+ System of provision of power and launch
+ Electric motor equipment
+ Systems of control of the motor
+ Box of dislocation of gear
- Union and ends of power
Specifications
Union - the general information and check of a condition of component ones
Removal and installation of the main cylinder of union
Removal and installation of the executive cylinder of union
Removal of air of a hydraulic way of the walk of extinguishment of union
Removal, check of a state and installation of component ones of meeting of union
Check of a state and substitution of the load of direction
Removal, check of a state and installation of the load of launch and fork of extinguishment of union
Agreement of a pedal of union
Check of a state, substitution and agreement of the switch of sensor of disconnection of a chain of an author
Removal and installation of ends of power
Removal and installation of an intermediary end (model of Full text)
Substitution of protective coverings and check of a condition of UNIONS of HP
+ Brakes system
+ Support of the triangular form of interruption and direction
+ Body
+ Electric side equipment
|
Removal, check of a state and installation of the load of launch and fork of extinguishment of union
|
|
Remember that the powder produced in the course of the use of bedcovers of friction of the driven plate of pressure can contain harmfully to the health asbestos. Do not take the compressed air of powder and try not to inhale it. Do not apply to the friction of component ones of solvents of union in an oil base, – they use only special detergents of brake or alcohol of metilo purely. Put the rags used in the hermetically shut container. |
Removal
To check
|
|
|
|
1. Property of the load of an extern bearer, hold tight that I intern and make it revolve (companion sees an illustration). The load will revolve freely and silently, otherwise it has to be substituted. |
2. Rub to be patient with pure rags and examine in the existence of signs of use, slits and other mechanical damages. Normally the substitution of the load of launch is done every time in the service of component ones of the union. Do not wash out the load in the solvent to avoid the violation of the tension of his meeting in absolute. Also mark the lever of the commutation of the union of existence of slits and signs of deformations. |
|
Installation
|
|
|
|
1. Fill an internal flute of the launch that loads heat-resistant lubricant. Lightly the fat with the same lubricating openings of a pin of a main end of the transmission and the bearer of the load of the last one (companion sees an illustration). |
|
|
2nd. It wets with the same lubricant a nest under landing of a spherical finger of a reverse side of a fork of extinguishment... |
|
|
2b.... and also a nest under the landing of an empurrador of the executive cylinder (companions see illustrations). |
|
|
2c. Polish a spherical finger of a spherical support of the lever of the inclusion. |
3. Between in the launch load in the gear with an union that puts fork out.
4. Put the connection with the bearer of the advanced load of a main end of the transmission, at the same time passing the end of a fork of the extinguishment through an opening in an union covering. Densely put an extinguishment of fork in a finger sharovy of a spherical support.
5. Lightly it wets with heat-resistant lubricant the surface of the load of launch to contact to diaphragm spring petals.
6. The new installation is done as it must be, the return to an order to be demolished. |
|
|
|
