Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Check of usefulness of functioning, substitution and agreement of the switch of sensor of lights of the brake

To check

ORDER OF REALIZATION

1. Squeeze out a pedal of a foot they brake and make sure of the usefulness of the operation of lights of the brake in meetings of combined lamps of the back. 2. If they do not work the lights of the brake, check a condition of the lock of corresponding security (to see the electric equipment of Front Side or the manual of operation in the car). Also check a condition of filaments of lamps of lights of the brake so much in lamps behind combined, just as in lamps of a light of the brake of the high level. 3. If the lamps and a security lock like debit should be, finds the switch of sensor installed in the superior part of a pedal of a brake of foot. 4. Disunite to electric capture of the switch of sensor (companions see illustrations). 5. In the Civic condutividade of check of models between the capture slap 1 and 2. In the pedal it had been held tight of a foot brake a condutividade has to happen, in the launched one – not if these conditions are not satisfied, they will substitute the switch of sensor. in Full text the models use an ohmmeter and check that the condutividade between the capture slap B and C. Besides, in the pedal condutividade held tight out it has to happen, in the launched one – not. In case of the necessity they substitute the switch of sensor.

Substitution

ORDER OF REALIZATION

1. Desconecte an electrical system of the switch of sensor. 2. A countersow gives in the party of the switch of sensor turned to a pedal, soon there results the last of the basic arm. 3. The installation is done upside-down.

Agreement

ORDER OF REALIZATION

1. Launch a countersow of the sensor they call and result the last thing so that his diver rested against a pedal of a brake of foot. 2. Weaken a countersow of an empurrador and, making spinning the pliers of last flat nose, adjust properly the height of the provision of a pedal (to see Specifications). 3. Again strongly hold tight a countersow. 4. Screw the switch of sensor in an arm so that his diver drowned himself completely (the remains of tip of woodcarving against a bedcover of the lever of a pedal), soon it turn behind in 1/2 turns and strongly hold tight a countersow. 5. A pressure of the hand had been a pedal of a foot curb and it measures the size of free his to go round. Compare the result of the measurement to Specifications demands. One secures of the usefulness of the operation of lights of the brake holding tight a pedal of brake.