Honda Tsivik
+ Cars of the mark of It Treats Full text and Honda Civic With care
+ Maintenance education
+ Regular maintenance
+ Motor
+ Cooling of system and heating
+ System of provision of power and launch
+ Electric motor equipment
+ Systems of control of the motor
+ Box of dislocation of gear
+ Union and ends of power
- Brakes system
Specifications
System of antiblockade of brakes (ABS) - the general information and codes of bad functioning
Substitution of shoes of brake of mechanisms of brake of disc
Removal, repair and installation of supports of mechanisms of brake of disc
Check of a state, removal and installation of a disc of brake
Substitution of boots of mechanisms of brake of drum of rear wheels
Removal and installation of cylinders of wheel
Removal and installation of the cylinder of main brake
Check of a state and substitution of lines of brake and hoses
Extraction through bomb of the system of brakes
Check of usefulness of functioning / tension, removal and installation of meeting of the amplifier of vacuum of brakes
Agreement of the brake of parking
Substitution of a thread (threads) of the walk of the brake of parking
Check of usefulness of functioning, substitution and agreement of the switch of sensor of lights of the brake
Check of usefulness of functioning and substitution of the switch of sensor of level of fluid of brake
+ Support of the triangular form of interruption and direction
+ Body
+ Electric side equipment
|
Removal and installation of cylinders of wheel
|
|
In case of holes the wheel cylinders are subject to the substitution without fail. The manufacturers do not recommend to do attempts of the realization of repair of recuperation of these knots of mechanisms of brake. |
Removal
|
|
1. A car behind also establishes it the Poddomkratta in stakes. Support advanced wheels boots you were antishowing.
2. Withdraw the drum of brake and boots (to see the Substitution of boots of mechanisms of brake of drum of rear wheels).
3. Compensate for the cylinder of wheel and surfaces that surround it with the dirt.
|
|
4. Desconecte to hydraulic line of a rear part of the cylinder of wheel (companion sees an illustration). To avoid that an ending of shlits of the union uses a key of special hat with a chief who cuts. In a lack of interest they do not pull for a metal tube of the line of brake to avoid his able deformation it is essential to complicate the proceeding of the connection. At the same time to a zakuporta the open end of the line of brake for aims of the reduction to the minimum of losses of liquid and to avoid the blow in the hydraulic system of the dirt. |
5. Give two pins of the fixation of the cylinder of wheel (to see an illustration in top).
6. Withdraw the cylinder of wheel of a council of brake and transfer it to a pure bank.
|
|
If in bedcovers of friction of boots of brake there are aspects of hydraulic liquid, the boots must be substituted, and carefully smooth the surface of work of the unsteady movement. |
|
|
Installation
|
|
1. Polish the inter-connected surfaces of the cylinder of wheel and a council of brake with the selante RTV. Install the cylinder at the regular place and join the hydraulic line. Still do not hold tight the nut of nipple.
2. The pins of fixation of screw and strongly they hold tight us. Now it is possible to hold tight a nut of nipple finally. Establish in the meeting of shoe of place.
3. Pump on the system of brakes (to see the Extraction through bomb of the system of brakes).
4. Before the initial operation of the car, one secures of the usefulness of the functioning of brakes. |
|
|
|
