1. Check a condition of locks of security and all the terminal connections of the corresponding electric chain. One secures of the perfection of a load of the battery.
2. Transfer transmission to the situation "P", lifts the parking they curb and turn the key of ignition in the position of in, without beginning the motor.
|
|
3. Without desconectar an electric motor of supporter of heater, joins a point of passage of wire to the capture of a dark-blue wire of a reverse side of the capture of the motor (companion sees an illustration), fuse the opposite end of a wire in the weight. If it begins the motor working, therefore the cause of the failure is in the bad functioning of the switch, resistores or an electrical system that is joined. |
4. If the motor does not work in the established capture of a dark-blue wire, to withdraw a point of passage of wire, disunite the capture and through the measure tension of voltômetro between the capture of a dark-blue wire and I weigh (to see an illustration in top). In all the models if the voltômetro fixes the tension of battery, and the motor does not work, in one of the ways of high speed, does his substitution (to see the Removal and the installation of an electric motor of the walk of the supporter of a heater). If the tension if it is going away, checks a condition of the alternation of the motor and an electrical system that is joined (to see the electric equipment of Front Side).
|
|
5. The meeting of resistor is located in a covering of an electric motor of driving of the supporter (companion sees an illustration). In a payment several resistores that supply a possibility of the choice of the ways of high speed low and a half of the functioning of the supporter settle down to the meeting. |
|
|
6. If it spins the motor, nevertheless be no possibility of the choice of one of the ways of high speed, withdraw the meeting of resistor of a covering of a heater and visually the damages existence checks it. through a check resistance of ohmmeter between captures 2 and 4 (companion sees an illustration). If someone of resistores will show off resistance below of the standard or will be the same as the infinity, substitute the meeting. |
|
|
