Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Removal and installation of meeting of the panel of control of functioning of a heater and condicionador of air, agreement of a thread of driving

The cars considered in the present manual are equipped of the system of the additional security of men better known as a cushion of security. Before executing any work near to the meeting of a pillow or a column of direction, without fail desconecte the system to avoid to be injured as a consequence of his chance operation (to see the electric equipment of Front Side).

ORDER OF REALIZATION

1. Desconecte a negative wire of the battery. Desconecte a security cushion (to see the electric equipment of Front Side).

If the stereosystem established in the car if it equips of a security code before desconectar the battery they secure what has the correct combination of the entry of the system sound in the action!

2. Withdraw the lowest section of the finish of the central consolation (to see the Chief Kuzov).
3. Withdraw a stereosystem (to see the electric equipment of Front Side).

4. Result screws of the fixation of the deflector of an air tube of the central consolation, take the deflector and give four screws of the fixation of the meeting of the panel of control of the functioning of the aquecedor/condicionador of air (companion sees an illustration).

5. Take the meeting of the management and disunite the capture of his electrical system. Desconecte a thread of the management of mixture of the air given to the hall of a lever of control (companion sees an illustration).

6. The installation is done upside-down.
7. The motor begins and check an isravnost of the functioning of systems of air conditioning and heating.

Agreement

Thread of management of mixture of the air given to hall

Civic models

ORDER OF REALIZATION

1. Since the agreement of a thread of driving the desconecta of the executive lever of the valve of a heater in a reason compartment. Desconecte a thread of the lever of the mixture of air of the meeting of the management below the panel in the interior of the car.
2. Transfer a temperature of lever of control to the provision of the cooling of maximum (FRESH MOVEMENT), then exactly pull for a covering of a thread and close the door, having followed the trace that the whole weak point a thread chose.
3. The property of a control raises with lever the air mixture that pulls out against the stop latch a thread of driving in an armband clip.
4. In a reason I compartmentalize that they transfer the executive lever of the valve to the completely shut position and join a thread. Without launching the lever, choose a weak point of end, having pulled for his covering, soon establish the clip of fixation.

Models of Full text

ORDER OF REALIZATION

1. Launch a thread of driving of a clip of armband of lever of control.
2. Transfer a temperature of lever of control the position of the very intensity of to heat (MOVEMENT OF HEAT), soon become a mixture of lever of control of air and join a thread.
3. Delay a covering of end of a tip behind, having chosen the whole weak point of a thread, soon a clip registers a thread.

Thread Driving of the valve of a heater

ORDER OF REALIZATION

1. Desconecte a thread of the lever of valve in a reason compartment. Desconecte a thread of the management of mixture of air of a lever of control below the panel.
2. Transfer a temperature of lever of control the position of the very intensity of to heat (MOVEMENT OF HEAT), turn the doorknob to a thread and the last one registers a clip. Holding tight a tip of end to an emphasis, bolt a thread of the management of air that is mixed in a clip.
3. In a reason I compartmentalize that they transfer the executive lever of the valve to the completely shut position and join a thread. Without launching the lever, choose a weak point of end, having pulled for his covering, soon establish the clip of fixation.