Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Removal and installation of an electric heater and wide tank of the system of cooling

Removal

Electric heater

ORDER OF REALIZATION

1. Desconecte a negative wire of the battery. If the stereosystem established in the car if it equips of a security code before desconectar the battery they secure what has the correct combination of the entry of the system sound in the action! 2. Lift the parking they curb and support behind wheels you put that you were antishowing. A front of the car also establishes it the Poddomkratta in stakes. In the corresponding complete set they withdraw the fabric of antispray of an electric heater. 3. Empty the system of cooling (to see the Front Regular maintenance). If the substitution of cooling the liquid was done recently, guard for the new use. 4. In models with in desconectam of an electric heater of the line of a way of the cooling of ATF. be prepared to join the spilled liquid. 5. Disunite the capture (taken) of supporter's electrical system (supporters). 6th. The launch collars and desconectam of an electric heater the best hose (companions see illustrations). 6b. Desconecte to hose lower of an electric heater. If the hoses "pricked" the tubes of branch are joined, use claws or knife (with the subsequent hoses substitution). 7. Remove the supporter (supporters) (to see the Check of a condition of the supporter (supporters) of the system of cooling and a chain of his inclusion; substitution of the supporter (supporters)). 8. Otboltite also liquidates firearms of the fixation of the superior edge of an electric heater to the ray of load (companion sees an illustration). 9. Carefully take an electric heater of a compartment of reason. Try not to spill the liquid that cools in the painted body lists and not to cut fingers on sharp plates of the conductor of heat. 10. After the removal the electric heater can happen for the existence of signs of holes, damages and violations of passability I intern of the heat conductor. Any repair has to be done only in the conditions of a specialized workshop with the use of the necessary equipment. 11. Remain of insects and the vegetation can be withdrawn of the space between conductor's heat plates blowing for the compressed air or is cleaned by a gentle brush. Try not to bend fine plates of the conductor of heat and not to cut on them fingers. Do not forget of putting wide eyes! 12. Check that a condition of the support of rubber of an electric heater, in case of the necessity they do the substitution.

Installation

ORDER OF REALIZATION

1. The installation is done upside-down. Fairness of trace of placing of pillows of rubber of support of the lowest part of an electric heater. 2. In the realization of the installation they fill out in the mixture of antifreeze of system with the water of the necessary structure (to see the Front Regular maintenance). 3. The motor begins and it is checked by the existence of signs of holes. Heat the motor up to the temperature of normal work (both hoses of an electric heater will be hot to the touch). Check that the level of cooling the liquid, in case of the necessity they add the corresponding amount of the mixture. 4. In models with for the CHECK the level ATF, in case of the necessity they add.

Wide tank

ORDER OF REALIZATION

1. The wide tank of the system of cooling is located near to an electric heater in the right advanced corner of a compartment of reason. 2. Walk in a hose of excess of a mouth of electric heater to the superior part of a wide tank. Discover together with the hose joined him. Withdraw a tank, having pulled it vertically and having launched of basic arms. 3. Liquid of cooling of fusion of a wide tank in the prepared capacity. 4. Wash out a tank and it is checked by the existence of slits and other damages. In case of the necessity they do the substitution. The dish does a tank on the outside of the quiet person with the soap and a brush – the level of the liquid that is in him has to be read easily by translucent walls. 5. The installation is done upside-down.