Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car



Honda Tsivik
+ Cars of the mark of It Treats Full text and Honda Civic With care
+ Maintenance education
+ Regular maintenance
- Motor
   - Repair of the motor without extraction of the car - the Civic model
      General information
      The preparatory actions and the list of proceedings of repair that can happen without the extraction of the motor of the car
      Reduction of the piston of the first cylinder in the provision of the superior dead point (TDP)
      Removal and installation of a covering of a head of cylinders
      Removal and installation of the oil pipeline of entry
      Removal and installation of a final collector
      The systems VTEC - the general information and check of a condition of component ones
      Removal, check of a state and installation of meeting of yokes
      Spring substitution valvate with plates and hats maslootrazhatelny
      Removal, check of a state and installation of a belt that distributes the gas and cog-wheels of GRM drive
      Substitution of an advanced epiploon of an end of inclination
      Removal, check of a state and installation of the axle
      Removal and installation of a head of cylinders
      Removal and installation of the trundle bed of a case of the motor
      Removal, check of a state and installation of the bomb of oil
      Removal and installation of a pendulum / driving of disc
      Substitution of a few back epiploon of an inclination end
      Check of a state and substitution of support of a support of the triangular form of interruption of the unity of power
   + Repair of the motor without extraction of the car - the Full text model
   + General and repairs of capital of the motor
+ Cooling of system and heating
+ System of provision of power and launch
+ Electric motor equipment
+ Systems of control of the motor
+ Box of dislocation of gear
+ Union and ends of power
+ Brakes system
+ Support of the triangular form of interruption and direction
+ Body
+ Electric side equipment


5dfc58ab

Substitution of a few back epiploon of an inclination end

 ORDER OF REALIZATION

1. Withdraw the transmission (to see the Chief Korobk of the dislocation of gear).
2. Withdraw a pendulum / a disc of driving (to see the Removal and the installation of a pendulum / a disc of driving).
3. Before the removal of an old man epiploon certainly they measure the size of slit between his surface of face and the exterior edge of the bearer (use a small sovereign or Columbus). Write when they resulted from the measurement – the new epiploon has to put itself strictly in the same depth (there see the Part the General repairs and the repairs of capital of the motor of the present Chapter).

4. The substitution of an epiploon can be done without introduction they are demolished of the trundle bed of a case and the bearer of an epiploon. Having hooked exactly the screwdriver up, take an old man epiploon of a landing nest in the bearer (companion sees an illustration).


Not to damage a pin of an end or a wall of a nest they roll up a few rags of prick of screwdriver.


5. Lightly the edges of fat of a pin and a sponge again epiploon with the universal lubricant, then, when a blunted instrument is helped, put an epiploon an end (companion sees an illustration). Through a mandrel and the hammer they put an epiploon in a nest (like a mandrel the head of face of the corresponding size, or a part of a tube of the convenient diameter can be in use [there is lightly less exterior diameter of an epiploon]).


The description of the proceeding of the substitution of an epiploon with demontazhy the bearer supplies with himself in the Part the General repairs and the repairs of capital of the motor of the present Chapter.


5. The new installation is done as it must be, behind to an order demolish.
6. The motor begins and check his existence of the hole of oil.