Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Removal, check of a state and installation of meeting of yokes

The loads of the axle are discovered together with the yokes meeting. To avoid an axle vyskakivaniye below the influence of the effort of a tension of a belt that distributes the gas, ask a spectator to maintain an end and at the same time to establish at the place a covering of the extreme load (it is supposed what the belt of GRM drive does not withdraw).

Having discovered loads of axle, attentively check a condition of both loads and his necks in an end (to see the Removal, the check of a state and the installation of the axle).

Removal

ORDER OF REALIZATION

1. Discover a head of cylinders (to see the Removal and the installation of a covering of a head of cylinders.
2. Bring in the provision of VMT the piston of the first cylinder (to see the Reduction of the piston of the first cylinder in the provision of the superior dead point (TDP)).

3. Ask a spectator to maintain the end of the axle turned to the transmission, then, in stages (in turns of 1/4 of the approximation), in the necessary order (to see an illustration) weaken pins of coverings of loads so that the effort developed per springs valvate was withdrawn.

4. Take the meeting of yokes with axes of a head of cylinders (companion sees an illustration).

Masloraspylitel (only driving of VTEC)
5. Take a spray of a head of cylinders.

To check

ORDER OF REALIZATION

1. Having withdrawn the meeting of yokes, it will be reasonable to investigate it for aims of more detailed to study of a condition of component ones. Result fixation pins and withdraw of axes of a yoke, one spring and a loads covering.

In the equipped motors of the system VTEC it will be reasonable to fix yokes of primary and secondary valves of entry with rubber bandages. Mark the provision of axes of yokes regarding loads coverings. Try to put the component ones withdrawn like his installation as in the meeting they have to put themselves strictly at the ancient places.

2. The component carefully clear ones and they check to us the existence of signs of use and damages. Appreciate a condition of the surfaces of yokes to contact to the axle (companion to see an illustration). Check existence of zadir and signs of the excessive use of a surface of the landing yoke in axes, and also walls of the landing of the nests of the yokes. The component incorrect ones are subject to the substitution. Also one secures of passability of maslotok.

3. Take a masloraspylitel.

Installation

ORDER OF REALIZATION

1. The oil all component pure reason and it establishes them at the regular places in a yokes axle.

Pay attention to the marking, the component ones of left side they are distinguished of the right.

2. In the equipped motors of the system VTEC they substitute a ring of fighter of a masloraspylitel, soon they establish the last thing at the regular place in a head of cylinders.
3. Cames of fat and necks of the axle with lubricant of special agreement. A fine layer of the selante anaeróbico shows up then they establish the meeting of yokes at the regular place in the surfaces of coverings of the first and sixth loads of the inter-connected axle to a head of cylinders.

4. In stages on the correct order (companion sees an illustration) there insist pins of the fixation of coverings of the axle with the necessary effort.

5. The new installation of component ones is done as it must be, the return to an order of his be demolished. In the conclusion they do not forget of doing the agreement of slits valvate (if in him there is a need) (to see the Front Regular maintenance).
6. The motor begins and it is checked by the existence of signs of hole of oil and usefulness of the functioning.