Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Removal and installation of a covering of a head of cylinders

Removal

ORDER OF REALIZATION

1. Desconecte a negative wire of the battery.

If the stereosystem established in the car if it equips of a security code before desconectar the battery they secure what has the correct combination of the entry of the system sound in the action!

2. Discover with cylinders of heads of the distributor of ignition with the wires joined him by VV. Desconecte wires of the captures in a head of cylinders and his covering (to see the Front Regular maintenance). Do not forget of marking wires to avoid the violation of an order of the ignition in the meeting.
3. Mark and desconecte all the proceedings of a wire that obstructs the implementation and hoses of the case of a regulator and a covering of a head of cylinders.
4. Carefully rub a covering to avoid the blow of the garbage in a few front cylinders / meetings of the mechanism valvate.
5. To be results pins of the fixation of a covering of a head of cylinders – act as debit, the return specified in a picture (to see an illustration I lower).
6. Exactly discover together with the placing hunting. Putting of a podlipl for the inter-connected front surface, the hammer explores a covering with the gentle living creature for aims of the destruction of a layer of the selante. Do not do in the moment of all the attempts of there separates a covering for a poddevaniye his lever introduced between the inter-connected surfaces.

Installation

ORDER OF REALIZATION

1. Separate the old placing, then carefully smooth the inter-connected surfaces of a head of cylinders and his covering. Having scratched it had been aspects of the old man selante and fragments of the placing, rub surfaces with the rags moistened in the acetone.
2. A boy imposes selante RTV to corners where the inter-connected surface of a head is next to the meeting of yokes (companion sees an illustration). Wait approximately for five minutes, waiting for the time being from the beginning of the polymerism of the selante.

One secures that the superior layer of the selante lightly was hardened, only after him the installation of departure of a covering (in the conditions of the polymerism of increased moisture of the selante it can begin with a small delay).

3. Fill the placing of form in the flute that goes to covering perimeter. Put the captures of isolation for the passage in a covering, having polished them lightly with the soap water solution. Put a covering in a head, soon screw pins of fixation and hold tight them in that order (companion sees an illustration) with the necessary effort (to see Specifications).

4. The new installation is done as it must be, the return to a removal order. Before VV of wire that is joined, one secures of the confidence of the landing of selantes of rubber of captures of spark.