Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Removal and installation of the trundle bed of a case of the motor

Removal

ORDER OF REALIZATION

1. Heat the motor up to the temperature of normal work, soon establish of him the oil of motor and withdraw a filter of oil (to see the Front Regular maintenance). 2. Desconecte a negative wire of the battery. If the stereosystem established in the car if it equips of a security code before desconectar the battery they secure what has the correct combination of the entry of the system sound in the action! 3. The car also establishes it the Poddomkratta in stakes. Withdraw the protection of a case. 4. Withdraw a tube of reception of the system of the production of the carried out gases (to see the Head of the system of provision of Power and launch). 5. Result pins of the fixation of the trundle bed to the block of motor (companion sees an illustration). 6. When the hammer explored the trundle bed with the perimeter with the gentle living creature for aims of the destruction of a layer of the selante, separate it of the block (it does not do in the moment of all the attempts to hook the trundle bed up below the inter-connected surface). 7. Scratch had been all the aspects of selante and material of old placing of the inter-connected surfaces of the trundle bed and block. Withdraw insertions of fighter of face of the trundle bed or the block. Carefully rub the inter-connected surfaces with the rags moistened in the acetone. You clean openings of woodcarving and dry in the block.

Installation

ORDER OF REALIZATION

1. Wash out the solvent of trundle bed and carefully dry it. One secures of the lack of deformations of a flange of agreement of the trundle bed, in case of the necessity they put the trundle bed a flange in the block of flat Madeira and do a rikhtovka. 2. Impose a pillow of the selante of 3 mm of thickness RTV in a surface of in favor freemasonry of a flange of the trundle bed. Trace that selante asserted himself of the interior of very fast openings. 3. Exactly hold tight the trundle bed to the block. 4. The screw pins and in stages (in turns of 1/4 of the approximation) they hold tight us with the necessary effort (to see Specifications). Begin to corset with the pin, beside the center, and remove a spiral on the outside. Remember that the tug of the fixation is loaded of the holes development. 5. Fill out the oil of motor (to see the Front Regular maintenance), begins the motor and checks the trundle bed to holes existence.