Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Check of a state, agreement of effort of a tension and substitution of driving of belts, (each one 12.000 km of a race or time during 6 months)

To check

Driving, or V-shaped (as they call them sometimes), the belts are located in an advanced part of the unity of power and fulfill an important paper in the functioning of the motor and many other systems of the car. Inside some time the belts are subject to the use, and therefore, they have to be turned regularly according to the time-table of the regular maintenance of the car to avoid serious failures of motor that the correction of consequences can make into the copeck.

Family of present of belts V-shaped also multiburden.

The quantity of the worn-out belts of driving depends on a complete set of the car. The belts are applied to the walk of such unities you help like the creator, driving and water bombs, the compressor of condicionador air, etc. Depending on the scheme of an agreement of pulleys, it can put itself for a belt in the action more than one unity.

ORDER OF REALIZATION

1st. Kill the motor, open a monk's hood and find belts of driving in an advanced part of the unity of power. When a small lamp is standing out, the fingers feel belts in the whole his length, checking the existence of slits and stratification. Inadmissivelmente also the presence in a belt of atritos, zapolirovanny to the lustre of sieges and other obvious defects (companions see illustrations). 1b. Examine belts of two sides on what overrolls them up. 2. The control of the effort of a tension of a belt happens for a nazhimaniye in him for a thumb of the hand in the siege in the environment between two next pulleys. The pressing will be quite firm. The effort of characterization of parameter of a tension of a belt is the size of his deflexão in a nazhimaniye (companion sees an illustration). As a rule, if the pulleys defend one of other in the distance of 180 for 280 mm, the size of a deflexão will do 6,4 mm, in the distance between pulleys 305÷405 mm, the deflexão of a belt of the form of wedge will do 12,5 mm, multiburden – 6,4 mm.

Agreement

In case of the correction of necessity of the effort of a tension of a belt of driving, one does in the turn in the relevant party of the unity given by him.

ORDER OF REALIZATION

1st. Since the correction of a tension of a belt of the walk of the creator weakens axial pins and they adjust of the fixation of the last one and it moves the unity in the relevant party (companion sees an illustration). 1b. Having finished the agreement, hold tight pins. The compressor K/V, on the contrary, concentrates rigidly, nevertheless it is equipped of the roll of tension that there allows to do the correction of the effort of a tension of a belt (companion to see an illustration). 1c. For the correction of a tension of a belt of the walk of the bomb of direction it is necessary to launch pins of agreement soon to use a lamb of nut in models or to move an accommodation of bomb in the relevant party, in others. 2. Having finished the agreement, one secures of the fairness of a tension of a belt (to see in top). In case of the necessity they repeat the proceeding of the agreement.

Substitution

ORDER OF REALIZATION

1. Since the substitution of a belt of driving weakens pins of the fixation of the unity / a roll of tension as they did it in the agreement and they get rid of a pulleys belt. It does sense to do at the same time the substitution of all the belts of driving at the same time. Before taking away finally a belt of the car, mark the direction of the rotation of a belt and the scheme of his placing in pulleys currents. 2. After the purchase of new belts they take with you old man as samples – the replaceable belts will correspond strictly old in a so great standard. 3. After the realization of the substitution they adjust a tension of new belts (to see in top).