Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Check and adjust of slits of valves (each one 24.000 km of a race or time during 12 months)

To check

ORDER OF REALIZATION

1. The necessity of the agreement of slits valvate only appears after substitution or repair of component ones of the mechanism valvate. 2. The most simple way of the check of valves listens of the motor in a hood of unbuttoned monk. There indicates the lifted noisy context published by the mechanism valvate the necessity of the realization of agreement.

Agreement

The check and the agreement of slits of valves are done in the cold motor.

ORDER OF REALIZATION

1. Discover a head of cylinders (to see the corresponding Part of the Chief Dvigatel). 2. Having become an end of inclination, bring the piston of the first cylinder in the provision of VMT of the end of a step of the compression (to see the Chief Dvigatel). The end had had been seen in the direction of the normal rotation (in the direction of the movement of the pointers of the clock) until the etiquette of VMT in his pulley does not go with the rate in the lowest covering of a belt that distributes the gas, and marks in a cog-wheel (oh) of the axle (axles) it will not fall in a state during 12 hours. 3. Having brought the motor in this situation, it is possible to begin the check and the agreement of valves of the first cylinder (companion to see an illustration). 4th. Begin with the entry valve. An edge of the probe fills the necessary thickness of measuring (to see Specifications) in a slit between a face of end of a nucleus of the valve and a yoke of the walk of the valve (civic Model), or an edge of work of the corresponding came of the axle of entry and the lever of the walk of the valve (model of Full text) (companions to see illustrations). 4b. The probe will insert a slit with an insignificant resistance. In case of the necessity they weaken a countersow and weaken the screw of agreement, soon they begin to hold tight the screw, trying to obtain the necessary effect on a probe edge. 5. Having fixed the screw of agreement of a provorachivaniye to screwdriver, hold tight a countersow (companion sees an illustration). One secure what the slit in the course of the pressure of a nut did not modify, then, working in a similar way, in series adjust slits of the second valve of entry and final two. 6. Having become an end of inclination in 180 ° in reverse sense to the movement of the pointers of the clock (the pulley of the axle has to be turned in 90 °), bring the piston of the third cylinder in the provision of VMT of the end of a step of the compression. At the same time the etiquette in a cog-wheel (oh) of the axle (axles) will pass in the situation during 9 hours. Check and adjust valves of the third cylinder. 7. Become an end of inclination of 180 ° in reverse sense to the movement of the pointers of the clock (the etiquette (i) will fall during 6 hours) and adjust valves of the fourth cylinder. 8. Having become again an end of inclination in 180 ° (the etiquette (i) will pass in the situation during 3 hours). Also repeat the proceeding for valves of the second cylinder. 9. Having finished the agreement of valves, establish at the place a covering of a head of cylinders (to see the corresponding Part of the Chief Dvigatel).