1. Check that a condition of component ones of the system of cooling has to be done after the cooling full of the unity of power (not less than what during three hours after a motor stop).
2. Discover an electric heater so that in the first turn it links to the first emphasis on the left. If the whistle what Indian excessive pressure in the system will be heard they hope for his ending, then they hold tight a covering a palm down and keep on turning before the liberation on the left. Carefully wash out a clean water of covering of inside and on the outside. Also wash out a gooey mouth of an electric heater. Of the surfaces compensated for all the aspects of the corrosion they have to be withdrawn completely. The liquid that cools what is in the system will be quite transparent. If the liquid is painted in colors of a rust, the system has to wash itself out and to be filled of the fresh mixture (to see the Service of the system of cooling (depleção, washing and stuffing) (each one 48.000 km of a race or times during 24 months)). If the liquid level does not get the top, add in an electric heater a little more mixture of the necessary structure (to see the Check of levels of liquids (each one 400 km of a race or weekly)).
|
|
3. Attentively examine the top and hoses of electric heater more you go down together with the hoses of the system of the heating of the hall that has less diameter, and located between the unity of power and a splitting of a compartment of reason. Check hoses in the whole his length and in case of the identification of slits, swellings and signs of the aging of the material it does the substitution of incorrect component ones. It is normally more simple to decipher small slits holding tight a hose (companion seeing an illustration). In spite of a state it is necessary to modify hoses approximately time during two years. |
4. Check the confidence of the fixation of all the hoses in the unions / branch tubes. The hole of cooling the liquid is shown normally in the form of potek of the rusty or white color in the surfaces that go round his fountain. If the hoses concentrate on unions / branches tubes for collars of the twisted type, there will be useful last fiável substitutes the worm more or I ponder.
5. To take compressed air, or through a gentle brush, withdraws of slits between conductor's plates of heat of electric heater old leaves, remains of insects and another garbage. Try not to damage gentle plates of the conductor of heat and not to cut fingers on his sharp edges.
6. Each second check, and also in the first signs of the violation of the functioning of the system of cooling it carries out the control of a covering of a pressure of electric heater. If near to the hand there is no convenient equipment, ask the help in the workshop of repairs of the car. |
|
