Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Service of the system of cooling (depleção, washing and stuffing) (each one 48.000 km of a race or time during 24 months)

Do not allow the blow of the antifreeze in open parts of the body and the painted surfaces of the car. Immediately take away while washing incidentemente vein it spurts an abundant amount of water. Remember that the antifreeze is the extremely toxic liquid and his blow in an organism in few quantities is even loaded of the most serious consequences (up to a lethal result). Never leave the antifreeze guarded in the container closed forbidden evil and immediately join the liquid that cools spilled in a floor. Remember that the slightly sweet smell of antifreeze can attract attention of children and animal. On ways use of the liquid of carried out cooling is consulted with local authorities. In many regions of the world-wide special points in the reception different from the work of they are equipped. Do not establish the old liquid of cooling in the piping and in the land in absolute!

Recently the degrees of nontoxical of the antifreeze were developed, nevertheless also they demand the care in the address.

Regularly, according to the time-table of the regular maintenance of the car (to see the Time-table of the regular maintenance), the cooling system has to be emptied, to wash itself out and to fill of the fresh mixture of the antifreeze with the water. Such a service allows to prevent the development of the corrosion in a way that cools and considerably it increases the efficiency of the functioning of the system.

During the service also the condition of all the hoses of the system and a covering of a gooey mouth of an electric heater (to see the Check of a condition of component ones of the system of cooling without fail has to happen (each one 12.000 km of a race or times during 6 months)). The component incorrect ones are subject to the substitution.

One does not forget of measures for precaution that have to be observed in the service of the system of cooling (to see the prevention in top).

Depleção

ORDER OF REALIZATION

1. Lift the parking they curb and support wheels you put that you were antishowing. It is necessary to begin straight proceedings of execution of the service only after the cooling full of the motor, this is not less than several hours then after the end of a travel.

2. Having hoped for the final cooling of the motor, discover a mouth of an electric heater and a wide tank (companion sees an illustration).

3. Acquire the capacity of the quite big volume below the door of drain of an electric heater. Having opened the door (companion seeing an illustration), more low cooling the liquid. To it carries not to give in to the opening due to the damage for the corrosion, desconectar – they try the lowest hose of an electric heater not to allow blows of the antifreeze in eyes and in open sieges from the skin.

4. After the realization of an effluence of cooling the liquid of an electric heater they withdraw the lowest hose of the last one and establish the liquid it remains on the superior part of the block of the motor.
5. While liquid fusions of the block, desconecte a hose of a wide tank and it withdraws the last thing (to see the Head of the system of Cooling and heating). Wash out a clean water of tank (in case of the necessity – with the soap). The clear level marks in tank walls.
6. Check a condition of hoses of electric heater and hoses of the system of the heating, and also collars of his that clings unions and tubes of branch (in case of the necessity sees the Check of a condition of component ones of the system of cooling (each one 12.000 km of a race or times during 6 months)).
7. Substitute the damaged component ones (in case of the necessity sees systems of Cooling and heating).

Washing

ORDER OF REALIZATION

1. After the realization of the depleção of the system they withdraw the thermostat of the motor, take it of a covering and establish the last back at the regular place (emptiness). Now the system is ready to the washing.
2. Establish at the place the lowest hose of an electric heater and hold tight the door of drain of the last one. Transfer the doorknob of the management of system of the heating of the hall to the utmost that is heated also to supply the washing of the conductor of heat of a heater.

3. Desconecte to hose better of an electric heater and insert a hose of garden in a tube of branch of the last one. Include the water distribution and keep on washing until the pure transparent current does not begin to follow of the best hose (companion should see an illustration).

4. In cases of specially strong pollution or violation of passability of an electric heater, withdraw the last thing (to see the Head of the system of Cooling and heating) and swallows him for repair of recuperation and service in a workshop of the service of the car.
5. The products of corrosion and dense deposits are withdrawn of a way by the chemical processing – follow manufacturers' educations of the detergent acquired by you.

In regular proceedings of execution of washing of the system and substitution of cooling the liquid of the necessity of executing the chemical processing of a way it must not appear.

Petrol station

ORDER OF REALIZATION

1. Install at the place the thermostat and a wide tank, join all the hoses to an electric heater.
2. Transfer the doorknob of the management of system of the heating of the hall to the very heating.

3. Slowly fill out in a fresh electric heater done in the necessary proportions (the mixture of antifreeze sees Specifications) with the water. Keep on being filled until the liquid level does not increase to the lowest reduction of a gooey mouth. In Full text the models weaken the special door in a covering of the thermostat and leave out of a way the air that is there (companion sees an illustration). Add the liquid that cools in a wide tank, when FULL COLDNESS brought his level to the mark. Wait for five minutes and re-examine the level of cooling the liquid in an electric heater, in case of the necessity they do the agreement.

4. Without establishing a covering in an electric heater, the motor begins and heat it before confiding of the valve of the thermostat (the liquid will begin the circular for an electric heater, at the same time there will be a heating of the best hose of the last one).
5. Kill the motor and leave us one abates. Add a little more liquid in an electric heater, having brought his level to the lowest reduction of a gooey mouth.
6. Corseting itself of the best hose of an electric heater they leave out of him the air, in case of the necessity they add a little more liquid than it cools. Establish at the place a covering of electric heater.
7. Doorknobs of transfer of the choice of temperature of the let one breathe and the choice of the way of high speed of the supporter to the very productivity.
8. The motor begins, heat it up to the temperature of normal work and system of control of the existence of signs of holes.