1. The check begins with the extern inquiry of the isolation of wires in the work motor. Direct the car in the fourth darkness, the motor begins and one secures of the lack of the sparkling in the wires joined with the exhaustion of his isolation. Try component furniture does not touch a reason compartment. Do necessary marks in the substitution of incorrect wires, soon leave the motor to us calm and there begins checks of a condition of a covering and the corridor of the distributor of the ignition.
2. The control of wires of candle happens in series to avoid the violation of an order of his connection in the meeting. Normally in the isolation of wires of company there is corresponding marking. In case of the absence that, they put it independently through an insulating tape and a marker.
3. Desconecte VV a wire of a capture of spark (the best of the whole use the special instrument). Do not pull for a wire, only for his tip in absolute.
4. Examine internal walls of a tip. The corrosion is shown normally in the form of a raid korkoobrazny fragile of the white color.
5. Move a tip in an end of the candle, one secures of the density of his landing. In case of the necessity again a rubber covering they withdraw a tip and the turn in league.
6. Rub with pure rags a wire in the whole his length, having withdrawn completely aspects of dirt and lubricant of the surface of the isolation. Examine the isolation of a wire in existence of slits, aspects of a progar and other damages. Try not to bend a wire below sharp angles to avoid the violation of the entirety of veins of the engineer in the isolation.
7. Desconecte a wire of the distributor (again only they pull for a tip, but not for a wire). Check a tip to existence of signs of the corrosion and density of the landing in the capture. Again a wire adheres to a distributor.
8. I work in a similar way, in series check that a condition of all remained candle wires. One secures from the confidence of his connection to candles and captures of a distributor.
9. In the necessity of the realization of the substitution of VV of the trace of wires that the replaceable wires were equal in the so great standard to parameters of the motor of his car. In shops of company of motor accessories and centers of services of the company of Honda it is always possible to acquire plays of VV of the wires, ready to the use, to cut in the length and equipped of hints. Withdraw and substitute wires in series to avoid the violation of an order of the ignition.
|
|
10th. Result screws of fixation (companion sees an illustration). |
|
|
10b. Withdraw a distributor's covering. Attentively check a covering I eat on the outside... |
|
|
10c.... and of inside (companions see illustrations) in the existence of slits, ways of coal, aspects of a progar, weakening of connections of contact and other damages. |
|
|
11th. Weaken the screw of fixation (companion sees an illustration). |
|
|
11b. Withdraw the corridor of an end of the distributor and examine it in the existence of slits and ways from coal (companion sees an illustration). |
12. The good practice is the substitution of a covering and the corridor of the distributor of the ignition in spite of his state every time during the installation of new VV of wires. When it uses component old men carefully smooth the surfaces of contact of his captures and it measures the resistant resistance of wires and a roof (to see Specifications to the present Chapter).
13. During the installation of a new covering of the distributor's transfer for him of old man VV of a wire, joining them it is strict in an ancient order – they try not desconectar all the wires at the same time, it transfers them in series.
|
|
