Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Substitution of liquid of automatic exchange (em/CVT) (each one 48.000 km of a race or time during 24 months)

The substitution of ATF has to be done in a regular base according to the time-table of the regular maintenance of the car.

ORDER OF REALIZATION

1. Prepare the fresh liquid of transmission of the corresponding degree (to see Specifications in the beginning of the Head).
2. Number of present of other necessary and material instruments: you stop short to fix of the car in the lifted situation, the walk of catraca in 3/8 inches (with the exoffer) to a face key, the drain capacity not less than 5 l and a stock of rags and / or old newspapers.
3. The liquid would fuse one heats up previously up to the temperature of normal work during a short travel. Hot ATF has the highest fluidity and better strip while washing the mud and other deposits.

The temperature of work of ATF can get 180 °C – be careful, I work in rubber gloves.

4. Having composed a short travel and the heating of ATF up to the temperature of normal work, park the car in the flat horizontal platform with a solid revetment and establish to his poddomkratta in stakes, having supplied the access release to a cork of drain of a case of the transmission.
5. Acquire the capacity of drain and the whole necessary stock below a case of transmission. Try not in concerning the located one below the bottom of the car of the heated component ones of the unity of power and the system of the production of the carried out gases.

6. When put properly a container of reception, there results the cork of drain located in the right side of a case of the transmission (companion sees an illustration). Do not forget what in the first moment of ATF will begin to follow with a relative pressure that, in the process of the reduction of the level of liquid, will lessen gradually – to be ready to correct the provision of the capacity of drain the time. When the liquid effluence absolutely for, rub a cork of drain, screw it at the regular place and strongly corset.

7. Lower the car in the land.
8. Without beginning the motor, take the probe of measuring of a case of transmission and through the launched opening they fill out the necessary amount of fresh liquid of the necessary degree (to see Specifications). For aims of the reduction to the minimum of losses of ATF they use a funnel. Fill out the liquid in the small portions, periodicamente checking his level in the probe (to see the Check of the ATF at the LEVEL (each one 4.800 km of a race or times during three months)).
9. The motor begins and slowly execute the selector's lever through all the provisions, having ended in the situation "P". Having ended, strongly lift the brake of parking.
10. Kill the motor and check the level ATF. In case of the necessity they do the corresponding agreement (the liquid level will be approximately in the environment the siege of an edge of the covered probe of entalhes.