Valves service In view of the complexity of sort of the work and necessity of use of the special equipment, valves service, the captures of direction and saddles the most correct thing will be to collect them to a people of service of the car. Such proceedings like the desmontagem of a head, primary cleaning and check of a condition of component ones of the mechanism valvate can be done by force itself of the owner of the car. Then it is necessary to join and to hand over a head for professional service in a workshop of the service of the car. The idea at the same time quite just from the subjects volume to the realization of the work normally takes a degree and the list approached necessary replaceable component ones can be prepared. The experts of a workshop will withdraw valves and springs valvate of a head and will do the necessary repair of recuperation or the substitution of worn-out component ones (valves, his saddles, the captures of direction, springs, spring plates and fine cookies of cutting locks). The hats substitution maslootrazhatelny is done without fail. After the meeting of component ones the spring agreement height valvate is going to happen. In case of the necessity the experts will do a front in favor point for aims of the restoration of planeness from his inter-connected surface. After the realization of the professional repair of a head his state normally corresponds to a condition again. Before the installation in the motor not to be too lazy to clean again carefully a head, when withdrew completely metal sawdust, aspects of an abrasive and another small garbage of production of all his cavities and channels. Blow all the compressed air of openings and channels (do not forget of putting wide eyes). |
