Honda Civic/Acura Integra

1. Through a special vertical furadeira completely they withdraw aspects of the use of step of the superior part of cylinders (companion sees an illustration) – they act according to the educations of the manufacturer annexed to a vertical furadeira. The step is formed in the edge of blow of piston, approximately in 6,4 mm below the superior reduction of the cylinder due to the mechanical production from metal and a nagaroobrazovaniye. The attempts of the extraction of conrod and without the removal of the development of step they are loaded groups of piston of the pistons damage.

4. Before withdrawing sticks of an end of inclination, appreciate that the size of his axial side benefits from necks of the last one. Densely between in an edge (edges) of the probe of measuring in a slit between a side wall of the lowest head of a stick and a face of a crank, having chosen completely a side of stick it benefits from a neck of end (companion sees an illustration). The total thickness of the chosen edges of probe also will be equal to the size of a play of axial side of a stick. Compare the result of the measurement taken the demands of Specifications. If the size of a play of axial side exceeds the extreme admissible value, this stick is subject to the substitution. The play of axial side of a new stick, or old man in the new for an end, can appear less than the lowest admissible limit, in this case the stick can be perforated – they are consulted with specialists of the service of the car. In series check all it remained that you pierce.

5th. One secures available in the lowest sticks leaders and his coverings of etiquettes of identification of the relevance to the cylinder – do not mix the number of a stick with the marking of the size of the conrod that overdoes (companion sees an illustration).

5b. In case of the necessity they put etiquettes independently through a small center punch.

7. Pull for the aims of hair clips of hair of the fixation of a few parts of covering of a hose of fuel to exclude any possibility of the chance damage of a neck of an end and a mirror of the cylinder in the course of the extraction of the meeting conrod from the last one (companion to see an illustration).

The installation of the stick that is subject to the extraction coaxialmente to the cylinder is done by the corresponding turn of an end of inclination – extraction of departure only after the stick is located strictly parallel to a cylinder axle!