Honda Civic/Acura Integra

Before pribolchivat to the motor the bearer with the new epiploon established in him, establishes at the place an end of inclination and the coverings of the radical loads.

1. Measure the regular depth of the landing of an old man epiploon in the nest of the bearer, soon put the edges of plate of the bearer in the couple of wooden blocks of the equal height and through a convenient current and the hammer beat an old man epiploon of the nest (companion saw an illustration). Try not to damage walls of nest.

2. Carefully the bearer rubs, soon polish the exterior edge again epiploon with the oil of pure reason. The epiploon has to put himself in a nest strictly perpendicularly, therefore, is not recommended the hammer does his blockage in the bearer. The absence of the access at a press the epiploon can fill in a nest through a great vice with gentle sponges – at the same time the bearer with an epiploon has to corset himself between two flat grindstones from wood that supply uniform distribution of the load in the whole area of a surface of face of an epiploon. The use of the hammer is allowed how last resource, nevertheless the zastukivaniye has to become for the grindstone from flat wood (companion sees an illustration). The law slowly, looking that there was no twist.

3. Through the probe of lezviyny type an epiploon and the bearer measure a slit between. The slit will have equal size in the whole perimeter of the bearer and not to exceed the limit of the 0.51÷0.76 mm variety.

Before the installation both surfaces of the placing must be polished with the selante RTV also.