Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car



Honda Tsivik
+ Cars of the mark of It Treats Full text and Honda Civic With care
+ Maintenance education
+ Regular maintenance
- Motor
   + Repair of the motor without extraction of the car - the Civic model
   + Repair of the motor without extraction of the car - the Full text model
   - General and repairs of capital of the motor
      General information
      Check of pressure of oil
      Check of pressure of compression in cylinders
      Diagnostic of a condition of the motor with use of the measure of vacuum
      Removal of the car of the unity of power - preparation and measured by precaution
      Removal and installation of the motor
      Alternative versions of schemes of repair of recuperation of the motor
      Order of desmontagem of the motor for preparation he to capital repairs
      Desmontagem of a head of cylinders
      To clean and check of a condition of a head of cylinders
      Valves service
      Meeting of a head of cylinders
      Removal of conrod and piston meetings
      Removal of an end of inclination
      Cleaning of the block of the motor
      Check of a condition of the block of the motor
      Honingovaniye of mirrors of cylinders
      Check of a condition of component ones of conrod and group of piston
      Check of a condition of an end of inclination
      Check of a state and selection of insertions of radical loads and conrod of an inclination end
      Order of meeting of motor
      Installation of rings of piston
      Installation of an end of inclination and check of slits of work of radical loads
      Substitution of a few back epiploon of an inclination end
      Installation of conrod and meetings of piston and check of size of slits of work in loads conrod of an inclination end
      Broken of proof and running in of the motor after capital repairs
+ Cooling of system and heating
+ System of provision of power and launch
+ Electric motor equipment
+ Systems of control of the motor
+ Box of dislocation of gear
+ Union and ends of power
+ Brakes system
+ Support of the triangular form of interruption and direction
+ Body
+ Electric side equipment


5dfc58ab

Cleaning of the block of the motor

 ORDER OF REALIZATION

1. Withdraw the bridge of coverings of (Civic) radical loads or the bridge and coverings (Full text) and take of the beds in coverings and the insertions of block of loads. It them inserts the mark through an insulating tape in the complaisance to the beds (loading number, a block / covering) and set aside they.

2. In the equipped models of Full text of the system VTEC to an otboltita also they withdraw of the block masloraspylitel (companion sees an illustration). The diameter of a mouth of a spray equals 1,27 mm and the 1 mm furadeira has to go on in his all the parts freely. Between in an end of a furadeira in an opening of entry of a spray and them pull out a ball of control. The ball has to move freely and for an otpuskaniye to return to an initial position due to the effort developed during one spring. In case of the identification of signs of the weakening of one spring, give the air pressed to an opening of entry. The ball has it surpassing the effort developed during one spring, to leave from a saddle with a pressure of not less than 1,96 kgfs/cm of 2, otherwise the spray is subject to the substitution.

3. The scratch had been all the aspects of the material of the old placing of the inter-connected surface of the block – it tries not to leave zadir.
4. Withdraw all the coverings and the hats of woodcarving of the galleries of oil of the block. The hats corset themselves normally much only, therefore, quite possibly, must be perforated with the subsequent restoration of a woodcarving in an opening. In the meeting of the block of a hat it is necessary to substitute new.

5th. Now it is necessary to take traffic jams of traffic of launch of a water shirt of the block. Through the hammer and a rude current coat embroiders one of a cork in the block, soon seize the opposite edge poured with claws...

5b.... they take a cork of the motor (companions see illustrations).


Try a cork does not go on and on incidentemente about the motor. Take all the traffic jams of traffic.


6. In the moment of the strong extern pollution of the motor it is necessary to bring him in a workshop of the service of the car of cleaning the steam or treatment of heat.
7. After the return of the block of a workshop again carefully they clean all his openings of oil and galleries – the cylindrical brushes with this finality special in the special form are given out (ask in shops of motor accessories). Wash out cavities and quiet person of channels – they keep on washing even from the opposite side of the clean water of block it does not begin to follow. Carefully dry the block, then lightly of oil all the perforated liquid of surfaces of the protection they of the corrosion. In the presence of the access to a fountain of compressed air they use it for the acceleration of the process of the drying of the block and a purge of remote cavities and channels.

During the work with the compressed air they do not forget of putting wide eyes!


8. In the moment of the strong pollution or a zashlakovyvaniye of the block it is necessary to resort to brush the cleaning for the hot water with the soap. It is not necessary to try to save the time at the expense of the negligent relation to the cleaning of the block. In spite of the chosen way, it follows the trace of the care of a clearing of remote cavities, channels and openings. In the conclusion there dries the block and oil the perforated liquid of surfaces of the protection they of the corrosion.

9. Banish all the openings shot in the block a faucet of the corresponding size (companion sees an illustration) for aims of a guarantee of the complaisance of indications of indicative of key of dynamometer the really developed efforts of corseting itself of the fixation in the meeting of the motor. Whenever possible, I punch then compressed air of openings, when they withdrew of all small garbage and shave. Having finished the processing of openings, a lerka walks for a part of woodcarving of pins.

10. Establish to the place of a covering of radical loads, having held tight to the hand his fixation.

11. Polish the surfaces of new inter-connected traffic jams of traffic of launch to the block with the selante (type n ° 1 of Permatex) and put them perpendicularly in the motor. In order that the special devices land of traffic jams of traffic of launch, some of which can be substituted with success with the head of convenient replaceable face by the size, they are given out (companion sees an illustration). The chief will enter in a cork somewhat densely.

12. There wet with selante noncongealable a woodcarving of new hats and a zakuporta they openings of galleries of oil. Durability of trace of pressure of hats.
13. If it is not going to begin immediately the meeting of the motor, put the block in a great plastic bag of the protection of his pollution.