Honda Civic/Acura Integra

from 1994 launch

Repair and operation of the car

Honda Tsivik
+ Cars of the mark of It Treats Full text and Honda Civic With care
+ Maintenance education
+ Regular maintenance
- Motor
   + Repair of the motor without extraction of the car - the Civic model
   + Repair of the motor without extraction of the car - the Full text model
   - General and repairs of capital of the motor
      General information
      Check of pressure of oil
      Check of pressure of compression in cylinders
      Diagnostic of a condition of the motor with use of the measure of vacuum
      Removal of the car of the unity of power - preparation and measured by precaution
      Removal and installation of the motor
      Alternative versions of schemes of repair of recuperation of the motor
      Order of desmontagem of the motor for preparation he to capital repairs
      Desmontagem of a head of cylinders
      To clean and check of a condition of a head of cylinders
      Valves service
      Meeting of a head of cylinders
      Removal of conrod and piston meetings
      Removal of an end of inclination
      Cleaning of the block of the motor
      Check of a condition of the block of the motor
      Honingovaniye of mirrors of cylinders
      Check of a condition of component ones of conrod and group of piston
      Check of a condition of an end of inclination
      Check of a state and selection of insertions of radical loads and conrod of an inclination end
      Order of meeting of motor
      Installation of rings of piston
      Installation of an end of inclination and check of slits of work of radical loads
      Substitution of a few back epiploon of an inclination end
      Installation of conrod and meetings of piston and check of size of slits of work in loads conrod of an inclination end
      Broken of proof and running in of the motor after capital repairs
+ Cooling of system and heating
+ System of provision of power and launch
+ Electric motor equipment
+ Systems of control of the motor
+ Box of dislocation of gear
+ Union and ends of power
+ Brakes system
+ Support of the triangular form of interruption and direction
+ Body
+ Electric side equipment

Desmontagem of a head of cylinders

The new or restored head of cylinders can always be ordered in a workshop of the service of the car or in a center of services of company of the warehouse of the manufacturer of company of the car. In view of the necessity of the use during the desmontagem and the check of a condition of a head of some special instruments, the authors of this manual think, of what to be acquired when what to an amateur mechanic more more cheaply will have to acquire a replaceable head in the quite complex repair of recuperation of the worn-out one was implicated.

ORDER OF REALIZATION

1. The desmontagem of a head of cylinders demands introduction they are demolished of the mechanism valvate (entry and final valves with the component companions). It is destined that the empurradores and the axles are already taken of a head (to see the Repair of Part of the motor without extraction of the car - the Civic model of the present Chapter).

2. Before the initial meetings removal valvate, prepare the necessary number of plastic bags appropriately marked to double in them component withdrawn (companion seen an illustration).

3. Through the special instrument they hold tight springs of the first valve and take of a flute in a few main fine cookies of the lock that cuts of a plate (companion sees an illustration). Carefully launch the instrument and withdraw of the valve a spring plate, springs and his saddle (depending on a complete set).

In the Full text models valvate springs are drowned and his pressure will need a special mouth to the instrument standard.

4. Besides, take the valve of a head of cylinders and withdraw a hat maslootrazhatelny of the direction capture. There if will be an interference of the valve in the direction capture, repel it in a head and an oselok or an archive with the small tooth exactly they smooth edges of a flute under the installation of fine cookies.

5. I work in a similar way, withdraw the meetings valvate remained. Put the withdrawn component ones of each one of valves in the separate one equipped with the polyethylene of corresponding etiquette – in the meeting each detail has to be established strictly at the ancient place.

Us models equipped of the system VTEC do not forget of taking of a front masloraspylitel with the hunting of rings (to see the Repair of Parts of the motor without extraction of the car - Civic models or Repair of the motor without extraction of the car - the model of Full text of the present Chapter).

6. After all the component ones of the mechanism valvate are overcome and they install an organized order, it is possible to begin to execute proceedings of the cleaning and check of a condition of a head (in the moment of the repair of full-scale recuperation of the motor before the end his desmontagem).